Idea Ws Slabanalysis of the floor slab and check according to
EC2
http://www.idea-rs.com/ideastatica
1
Creating of the new project and definition of the project data
2
1. Create a new
new project
2. Specify material
and thickness of
the slab
Definition of the outline of the slab
3
1. Button for adding/
removing nodes
of the outline
polygon
2. Specification of
the nodal suports
Definition of opening
4
1. Create/delete an
opening
2. Adding/removing
nodes of the
polygon which
defines the shape
of the opening
3. Specification
of the
support in
nodes or on
lines
Input of internal nodes
5
Adding of a new node
Removing of the
existing node
Type of the
support in the
node
Input of internal lines
6
Create a new line
Delete the existing line
Type of the
support on the
line
Definition of load cases
7
Create a new
loadcase
Type of the load
case – it can be
pernament or
variable
Uniform loading
on the surface
of the slab
Definition of load impulses in load cases
8
Create a new impulse
Type of the
impulse
Area where impuls is acting
Definition of load combinations
9
Set load coefficients for
load cases in the load
combination
Typo of the
combination
Create a new
combination
Running of the analysis and showing of results
10
Run
analyisis
Choose load
combination
Choose type of
the internal
force
Division of the slab into areas which have the same type of the reinforcement
11
There are defined two types of the reinforcement in this example.
A type 1 in green areas and a type 2 in orange areas.
Definition of check positions
12
Create a new position
The type of the
definition of
the check
position
(node, node
of the mesh,
mesh
element)
Specify the required type
of the reinforcement in
the position
Creating of the Idea Rcs project
13
Button for generation Rcs
project
(performance is going to be
improved)
List of extremes in
the check positions
Opening of the generated project in Idea Rcs
14
The list of the check
positions
(sections) on the
slab
The type of the
reinforcement
in the section
The list of the
extremes
belonging the
the check
position
(section)
Values of
the
selected
extreme
Input of the real reinforcement for types of the reinforcement which were defined in Ws Slab
15
Template of the
reinforcement – input of
parameters
Table of check results for all sections
16
Limiting check
values in the
check postions
(sections)
Check values for
extremes
Preview of the calculation protocol
17
Possible export to Idea ProDesign
18
Create project file for
ProDesign