CLEARWATERFOrmOsO Freestanding bath
Cleaning reCOmmendatiOns
To see the complete CLEARWATER range go to www.reece.com.au/bathrooms
sPeCiFiCatiOnsrecommended Use Domestic, Hotel and Commercial
size 1500mm x 750mm x 555mm
1700mm x 750mm x 555mm
material Composite Stone Solid Surface
Weight 1500mm: 92kg
1700mm: 120kg
Capacity to overflow
1500mm: 300 litres
1700mm: 362 litres
Colour White
thickness 18mm
disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.
tech Page Version 2
Formoso Piccolo 1500 x 750 x 555
Product SpecificationFinishes whiteProduct Type natural stoneMaterial natural stoneTap Holes 0Product Weight 92kgBath Water Volume 300 litres * / 230 litres *** Volume of water contained in the bath if filled to the overflow.** Volume of water contained in the bath if filled to the overflow less 70litres to allow for an average person in the bath. Additional InformationIntegrated overflowAverage thickness throughout the bath is 10mm
Guarantee
See our website for terms and conditions Compliance / ApprovalsBS EN14516:2006Baths for domestic purposes
All dimensions are in millimetres (mm)
Compatible ProductsCW1 - Click-Clack Waste (slotted), CW3 - P Trap
www.clearwaterbaths.co.uk
Formoso 1700 x 800 x 555
Product SpecificationFinishes whiteProduct Type natural stoneMaterial natural stoneTap Holes 0Product Weight 120kgBath Water Volume 362 litres * / 292 litres *** Volume of water contained in the bath if filled to the overflow.** Volume of water contained in the bath if filled to the overflow less 70litres to allow for an average person in the bath. Additional InformationIntegrated overflowAverage thickness throughout the bath is 10mm
Guarantee
See our website for terms and conditions Compliance / ApprovalsBS EN14516:2006Baths for domestic purposes
All dimensions are in millimetres (mm)
Compatible ProductsCW1 - Click-Clack Waste (slotted), CW3 - P Trap
www.clearwaterbaths.co.uk
Dimensions are nominal measurements only
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty- Refer to Warranty Conditions.
page 1 of 4
CLEARWATERFOrmOsO Freestanding bath
installatiOn instrUCtiOns
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
Important
• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport.
• Please check that all parts have been supplied.
• Assemble bath on a mat to protect against damage to bath surface.
• Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.
• This product requires a two person lift – use proper lifting techniques.
• This installation guide does not include details of waste connection; final decision about installation of waste connection should be taken by a suitably qualified person.
Parts supplied:
1x
1
4x
3
When fitting the waste, ensure the slotted side faces the overflow channel.
Slot
Overflowchannel
Parts supplied:
1x
1
4x
When fitting the waste, ensure the slotted side faces the overflow channel.
Slot
Overflowchannel
For more detail, refer to the instructions supplied with the waste Waste supplied in kit V75-DF muxt be used
4x
24H
Place the bath on two wooden blocks over the waste connections. Connect the waste. Fill the bath with water and check for leakage. Place the wedges in position.
The wedges can now be disposed of.
(wedges not supplied)
page 2 of 4
CLEARWATERFOrmOsO Freestanding bath
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
Cleaning and Repair Guide
Scratch
(For best results limit sanding to the smallest)1 Remove the deep scratch by rubbing with a 800+grit sand paper2 If needed continue to remove by rubbing with a 1500+ grit waterproof abrasive paper and water3-5 Using toothpaste to polish the area to get back the gloss surface6-7 For best results, use electrical polish pad with neutral automotive colour restorer or houshold metal polish.
Shoe Polish
1 Wipe off with a soft cloth2-4 Using toothpaste to polish the area to get back the gloss surface
1 2 3
4 5 6 7
1 2 3 4
Cleaning and rePair gUide
page 3 of 4
CLEARWATERFOrmOsO Freestanding bath
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
Grease or hand mark
1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.4-6 For the hard crease, using toothpaste to polish the area to get back to the gloss surface.
1 2 3
4 5 6
Pencil
1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.
Marking Pen
1-3 Using non abrasive bathroom cleaner or mild detergent to clean the area to get back to the gloss surface.
1 2 3
2 31
page 4 of 4