JCB TELESCOPIC WHEELED LOADERS | TM180 AND TM220
• Incredibleversatilityisachievedthroughcompactdimensionsandtheadditionalliftheightprovidedbyatelescopicboom
• Themanoeuvrabilityofarticulatedsteeringtogetherwiththeside-shiftfunctionforeasyloadplacingabilitygivesrealspotloadingprecision
• Aspaciouscabenvironmentwithintuitivecontrolsmakesoperationsimpleevenforthenoviceoperator
• Dailymaintenancecanbecarriedoutsimplyandsafelyfromgroundlevel
• Designedandmanufacturedtolast,onlythefinestcomponentsarecarefullyselectedtogivedurabilityandreliability
TELESCOPIC WHEELED LOADER | SPECIFICATION
TM180:MAX. ENGINE POWER: 46kW (62hp) MAX. PAYLOAD: 1800kg MAX. LIFT HEIGHT: 4534mm TM220:MAX. ENGINE POWER: 56kW (75hp) MAX. PAYLOAD: 2200kg MAX. LIFT HEIGHT: 4562mm
STATIC DIMENSIONS
Machine model TM180 TM220
A Overall Height mm 2477 2678
B Overall Width (over tyres) mm 1752 1905
C Wheelbase mm 2200 2205
D Ground clearance mm 301 329
E Height to top of boom pivot mm 1600 1667
F Wheel track mm 1396 1490
G Axle to shovel toe plate mm 2535 2498
H Axle to counterweight face mm 1254 1300
I Total length* mm 5989 6003
J Dump reach mm 1235 1175
K Dump height mm 3585 3652
L Load over height mm 4308 4376
M Pin height mm 4704 4772
N Max dump angle degrees 43 43
O Roll back at carry degrees 43 43
M
L
K
N
J
O
IHCG
D
aF
A
E
B
Machine model TM180 TM220
Inside Radius mm 2105 2090
Outside radius (edge of tyre) mm 3955 4030
Outside radius (over shovel) mm 4480 4755
Articulation angle degrees ±40° ±40°
Operating weight kg 5610 6080
Front axle weight kg 2310 2150
Rear axle weight kg 3300 3930
Specification
Tyres used for specifications Michelin XMCL Michelin XMCL
340/80 R18 400/70 R20
Bucket 0.8 m³ GP 0.9 m³ GP
Hitch Pin & Cone Pin & Cone
*Please note total length: machine fitted with standard bucket – boom fully down, shovel crowded fully back
TELESCOPIC WHEELED LOADER | SPECIFICATION
AXLES
BRAKES
Machine model TM180 TM220
Type Straight beam Straight beam
Make Spicer Spicer
Model 111 111
Overall axle ratio/ drop box ratio 19.30 / 2.10 19.30 / 2.10
Chassis angle oscillation degrees ±10º ±10º
Machine model TM180 TM220
Service brakes In board oil immersed brakes In board oil immersed brakes
Parking brake Spring applied, hydraulic release Spring applied, hydraulic release
ENGINE
Machine model TM180 TM220
Manufacturer Deutz Deutz
Model D2011 L04i TD2011 L04i
Capacity ltr 3.62 3.62
Bore mm 96 97
Stroke mm 125 126
Aspiration Naturally aspirated Turbocharged
No. of cylinders 4 4
Power rating
Gross power to SAE J1995/ISO 14396 kW (hp) 46 (62) @ 2500 rpm 56 (75) @ 2500 rpm
Net power to J1349/EEC 80/12 kW (hp) 43.5 (58) @ 2500 rpm 53 (72) @ 2500 rpm
Torque rating
Gross torque Nm 190 @ 1600 rpm 250 @ 1600 rpm
TRANSMISSION
Machine model TM180 TM220
Type Hydrostatic Hydrostatic
Make Rexroth Rexroth
Model A6VM - 2 Speed A6VM - 2 Speed
Low range kph 6 6
High Range kph 20 20
Max travel speed kph 20 40 - Optional
HYDRAuLICS
Machine model TM180 TM220
Pump type Tandem gear pump Tandem gear pump
Pump max. Flow l/min 60 78
Pump max. Pressure bar 230 250
Hydraulic cycle times
Boom Raise seconds 6.2 4.3
Boom Lower seconds 5.1 4.5
Extend seconds 5.3 3.6
Retract seconds 4.4 2.9
Bucket Dump seconds 3.9 3.4
Bucket Crowd seconds 4.1 2.8
Total Cycle Time seconds 29.0 21.5
SERVICE FILL CAPACITIES
Machine model TM180 TM220
Hydraulic tank & transmission litres 70 70
Fuel Tank litres 80 80
Engine oil sump litres 12 12
Axle oil (front) including hubs litres 4.4 4.4
Axle oil (rear) (*including hubs & drop box) litres 6.05 * 6.05 *
Drop box litres 6.05 6.05
ELECTRICAL SYSTEM
Machine model TM180 TM220
System voltage Volt 12 12
Alternator output Amp Hour 80 80
Battery capacity Amp Hour 105 105
All machines fitted with: Full road lighting, reversing light, direction indicators, battery isolator.
BOOM AND CARRIAGE
Boom is manufactured from high tensile steel. Low maintenance, hard wearing pads. One boom end hydraulic service fitted as
standard. Safety check valves fitted to carriage tilt; telescopic and boom lift rams. JCB Adaptive Load Control fitted in compliance
with EN1500.
TELESCOPIC WHEELED LOADER | SPECIFICATION
SERVICE FILL CAPACITIES
Machine model TM180
Max lift capacity to full height with forks kg 1800
Lift capacity at full reach kg 1100
Lift height mm 4534
Maximum forward reach mm 3107
Full turn tipping load - forks with 500mm load centre* kg 2250 *
Full turn tipping load- forks calculated @ 80% load factor* kg 1800 *
Full turn tipping load - forks calculated @ 60% load factor* kg 1350 *
Breakout force - tearout kg (kN) 4140 (40.6)
*Full Turn Tipping Load with forks direct mount to pin and cone quickhitch to EN474 (ISO 14397)
Machine model TM220
Max lift capacity to full height with forks kg 2200
Lift capacity at full reach kg 1250
Lift height mm 4562
Maximum forward reach mm 3041
Full turn tipping load - forks with 500mm load centre* kg 2750 *
Full turn tipping load- forks calculated @ 80% load factor* kg 2200 *
Full turn tipping load - forks calculated @ 60% load factor* kg 1650 *
Breakout force - tearout kg (kN) 4990 (48.9)
*Full Turn Tipping Load with forks direct mount to pin and cone quickhitch to EN474 (ISO 14397)
BOOM AND CARRIAGE
0 Metres12345
1
0
2
3
4
5
6
-1
0̊
10̊
40̊
70˚
50̊
80̊
20̊
30̊
60̊0m
0.32m
0.74m1.1m
1.2m95˚
-2˚
0.5m1100kg
1250kg
1500kg
1800kg
-1
6
0
012345 Metres
5
4
3
2
1
2200kg
1250kg
1500kg
1750kg
2000kg
0.5m20°
30°
40°
50°
60°
70°80°95°
0m
0.5m
1.0m
1.2m
10°
0°
-2°
TM180 TM220
TELESCOPIC WHEELED LOADER | SPECIFICATION
STANDARD/OPTIONAL EQuIPMENT
Engine and cooling
62hp Deutz engine ● x
75hp turbocharged Deutz engine x ●
Cyclonic air filter ● ●
Transmission / Axles
Hydrostatic transmission ● ●
40kph travel speed x O
Transmissions disconnect on footbrake ● ●
Forward / reverse controls on joystick ● ●
In board oil immersed disc brakes ● ●
Limited slip differentials front and rear O O
Hydraulics
Servo controls ● ●
Flow sharing hydraulics ● ●
Proportional boom and auxiliary controls ● ●
Adjustable constant flow hydraulics ● ●
Gear pump ● ●
Priority steer valve ● ●
Hose burst check valves ● ●
JCB Adaptive Load Control ● ●
JCB Smoothride system O O
Hydraulic tank cap lock O O
Biodegradable hydraulic oil O O
Cab
ROPS/FOPS safety structure ● ●
Laminated screen ● ●
Fully adjustable mechanical seat ● ●
Air suspension seat O O
Interior light ● ●
Tiliting steering column ● ●
Tilit and telescope steering column O O
Front and rear wash/wipe ● ●
3 speed heater fan ● ●
Air conditioning O O
LH opening door with door lock back ● ●
RH opening window with lock back ● ●
LH Sliding window O O
Single lever joystick controls ● ●
Loader control isolator ● ●
External rear view mirros ● ●
Front and roof screen blinds ● ●
Fire extinguisher O O
Additional storage box O O
Electrical
Road lights front and rear ● ●
Reverse lights ● ●
Battery isolateor ● ●
Direction indicators ● ●
Rotating beacon O O
Front and rear worklights O O
Boom worklights O O
Twin reverse light kit O O
Reverse foglight kit O O
Livelink telematics O O
Chassis & Bodywork
Articulated steering ● ●
Centre pivot oscillation ● ●
Plastic front and rear fenders ● ●
Fixed bottom step ● ●
Full width rear counterweight ● ●
Recovery hitch ● ●
Front Screen guard O O
Roof screen guard O O
Toothguard O O
Grease gun and cartridge O O
Loader
Centre mounted single stage telescopic boom ● ●
Parallel lift ● ●
End damping on boom lower and retract ● ●
JCB Compact tool carrier O O
Eurohitch O O
Pin and Cone (CAT II) O O
Electrical in cab pin isolation O O
●– Standard, O – Option, x – Not available
NB. Regional variations may apply to
standard and optional equipment
TM180 TM180 TM180TM220 TM220 TM220
TELESCOPIC WHEELED LOADER | SPECIFICATION
TYRE OPTIONS
Dimensions
Manufacturer Size Type Application Vertical Width over tyres
mm mm
Dunlop 405/70 R18 EM SPT9 EM -20 -12
Dunlop 335/80 R20 MPT SPT9 EM +1 -89
Dunlop 365/80 R20 MPT SPT9 EM +21 -55
Dunlop 405/70 R20 MPT SPT9 EM +14 -11
Goodyear 400/70 R20 IT520 Ag -4 -21
Goodyear 16.0/70 R20 SGL Ag +4 -4
Goodyear 420/75 R20 IT520 Ag +25 +6
Michelin 12.00 R20 X Mine D2 Waste +25 +6
Michelin 375/75 R20 XZSL EM 0 -17
Michelin 380/75 R20 XMCL Ag 0 -19
Michelin 400/70 R20 XMCL Ag 0 0
Michelin 405/70 R20 XMCL EM +23 +6
Michelin 405/70 R20 XZSL Ag +27 +6
Nokian 340/80 R18 TRI 2 EM -28 -69
Nokian 360/80 R20 TRI 2 EM +14 -55
TM220
Tables detail tyre options available. Dimensional changes stated relative to static machine dimensions.
Dimensions
Manufacturer Size Type Application Vertical Width over tyres
mm mm
Dunlop 335/80 R18 EM SPT9 EM +2 -25
Dunlop 365/70 R18 EM SPT9 EM -8 +44
Dunlop 405/70 R18 EM SPT9 EM +15 +88
Goodyear 12.5/80 R18 SGL Ag -9 -46
Goodyear 400/70 R18 IT520 Ag +7 +92
Michelin 340/80 R18 XMCL Ag 0 0
Michelin 335/80 R18 XZSL EM +15 -11
Nokian 340/80 R18 TRI 2 EM +7 -13
Solideal 12.5 R18 SLR4 Ag +24 -25
TM180
JCB Sales Limited, Rocester, Staffordshire ST14 5JP. Tel: 01889 590312. Fax: 01889 590588. Web: http://www.jcb.comJCB reserves the right to change specifications without notice. Illustrations shown may include optional equipment and accessories. The JCB logo is a registered trademark of J C Bamford Excavators Ltd. 9999/5560 03/13 Issue 2