IMAGING GROUP
Applications: Astronomy, Photometry, EL/PL Imaging,Luminescence & Fluorescence Imaging, and Bose-Einstein Condensate (BEC) Page 1 of 7
PIXIS: 1024 eXcelon Rev. N2
The PIXIS: 1024 series of cameras from Princeton Instruments (PI) are fully integrated, low noise cameras with 1024 x 1024 resolution designed for quantitative scientific imaging applications from UV to NIR. Based on PI’s exclusive XP cooling technology, PIXIS are the only cameras that offer cooling down to -90°C, with an all-metal, hermetically sealed design and the industry’s only lifetime vacuum guarantee. High QE and ultra low-noise electronics make the PIXIS: 1024 series of cameras ideal for demanding, low light applications such as astronomy, Bose-Einstein Condensate (BEC), solar cell inspection, chemiluminescence and fluorescence imaging. The exclusive B_eXcelon™ and BR_eXcelon technologies of the PIXIS:1024 deliver the highest sensitivity in the UV-NIR range while suppressing the etaloning that occurs in standard back illuminated CCDs. Dual speed operation at 100kHz or 2MHz enables these cameras to be used both for steady state as well as fast kinetics studies.
FEATURE BENEFITSBack-illuminated, deep depletion CCD with eXcelon™ technology (BR_eXcelon)
Highest QE in the UV and NIR range; High QE in the NIR range;Eliminates etaloning
Back-illuminated, eXcelon technology (B_eXcelon)
Lower dark charge than back-illuminated deep depletion CCDs; Extremely low etaloning
1024 x 1024 imaging array, 13 mm x 13 mm pixelsScientific grade CCD
High spatial resolutionLow noise, few defects, linear response
All-metal, hermetic vacuum seals; Lifetime vacuum guarantee
No out-gassing (as in epoxy seals) which can compromise vacuum performance;Worry free operation
Deep cooling Low dark noise allows detection of faint signals; CoolCUBE II, a compact room temperature coolant circulator, is available for vibration sensitive environments
Single fused silica vacuum window Minimizes reflection losses from UV to IR; No optical losses due to multiple optical surfaces;Optional AR coating and wedge windows available
Optional UV phosphor coatings Enhances sensitivity throughout the UV to below 200 nm (not available for eXcelon cameras)
TTL input and output, and shutter control External control and triggering
Low noise electronics Best performance for low light level applications
Dual digitizers Dual-speed digitization allows complete freedom to select between “slow operation” for low noise and highest SNR or “fast operation” for rapid image acquisition
Software selectable system gains Flexibility to optimize signal-to-noise ratio and dynamic range
Kinetics Custom readout mode offers microsecond resolution
USB2.0 data interface Plug-and-play operation with desktops or laptops; Optional fiber optic interface for remote operation
LightField™ for 64-bit Windows 7 or WinSpec for 32-bit Windows
Powerful, yet easy-to-use software packages for acquisition, display and analysis;LightField offers cutting edge interface, direct to hard drive streaming, time stamping & more
PICAM/PVCAM software development kits (SDKs) Universal programming interfaces for easy custom programming;Compatible with Windows XP/Vista/7 and Linux
P IX IS : 1024Now Powered by LightField™
IMAGING GROUP
Page 2 of 7PIXIS: 1024 eXcelon Rev. N2
@ 2 MHz @ 100 kHz
1 x 1 0.58 sec 10.0 sec2 x 2 0.28 sec 2.8 sec8 x 8 0.14 sec 0.85 sec
Readout Time
Binn
ing
FRAmE RATE
SPECIFICATIONS
CCD UV coating Optional UV coating (not needed for BUV version)CCD format 1024 x 1024 imaging pixels; 13 x 13 mm pixels; 100% fill factor
Imaging area 13.3 x 13.3 mm (optically centered)Lens mount Adjustable C-mount with integral 25mm shutter; spectrometer adapter availableDeepest cooling temperature -90°C typical; -70°C guaranteed, specified at ambient temperature of +20°CThermostating precision ±0.05°CCooling method Thermoelectric air or liquid cooling (CoolCUBE II liquid circulator available)Full well: Single pixel Output node
100 ke- (typical), 60 ke- (min)250 ke- (typical), 220 ke- (min)
ADC speed/bits 100kHz/16-bit and 2MHz/16-bitSystem read noise @100 kHz @2 MHz
3.0 e- rms (typical), 5 e- rms (max)9.0 e- rms (typical), 15 e- rms (max)
Vertical shift speed < 3.2 msec/row to18 msec/row (programmable)
Non-linearity <1% @ 100 kHzSoftware selectable gains 1, 2, 4 e-/ADU (typical); available at all speedsOperating systems supported Windows XP/7 (32-bit), Windows 7 (64-bit) and LinuxData interface USB2.0 (5m interface cable provided); Optional Fiberoptic interface is available for remote operationI/O signals Two MCX connectors for programmable frame readout, shutter, trigger inOperating environment +5 to +30°C non-condensingCertification CEDimensions / Weight 16.59 cm (6.53") x 11.81 cm (4.65") x 11.38 cm (4.48") (L x W x H) / 2.27 kg (5 lbs)
PIXIS: 1024BR_eXcelon PIXIS: 1024BR PIXIS: 1024B_eXcelon PIXIS: 1024B/BUV PIXIS: 1024F
Features Back-illuminated, deep depletion CCD with eXcelon technology. Highest QE in the UV
and the NIR.No etaloning.
Back-illuminated, deep depletion CCD. High QE in the NIR and no etaloning.
Back-illuminated CCD with eXcelon technology.Highest QE in the visible and high QE in the NIR. Extremely low etaloning. 5x - 100x lower dark charge than the BR.
Back-illuminated CCD.Highest sensitivity in the visible region.
Special BUV version offers the highest sensivity in the UV
region.
Front-illuminated CCD. Affordable technology for
moderate light level applications. No
etaloning.
CCD Image Sensor Princeton Instruments’ proprietary CCD with eXcelon technology,
grade 1, NIMO
e2v CCD47-10 back-illuminated deep depletion, grade 1, NIMO
Princeton Instruments’ proprietary CCD with eXcelon technology.,
grade 1, AIMO
e2v CCD47-10 back-illuminated, grade 1, AIMO
e2v CCD47-10 front-illuminated, grade 1, AIMO
Dark current @ -70°C (e-/p/sec)
0.02 (typical)0.07 (max)
0.02 (typical)0.07 (max)
0.0004 (typical)0.001 (max)
0.0004 (typical)0.001 (max)
0.0002 (typical)0.0007 (max)
All specifications subject to change
IMAGING GROUP
Page 3 of 7PIXIS: 1024 eXcelon Rev. N2
qE DATA
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
250 300 350 400 450 500 550 600 650 700 750 800 850 900 950 1000 1050
Wavelength (nm)
Qua
ntum
Effici
ency
(%)
BR_eXcelon B_eXcelon BR B BUV F(for non-eXcelon cameras only)With optional UV coating
NOTE: Graph shows typical Quantum Efficiency (QE) data measured at + 25°C. QE decreases at normal operating temperatures. For the best results for your application, please discuss the specific parameters of your experiment with your sales representative.
IMAGING GROUP
Page 4 of 7PIXIS: 1024 eXcelon Rev. N2
Back-illuminated
Back-illuminated_eXcelon
Data taken with white light source through a monochromator comparing etaloning performance of eXcelon vs. back-illuminated CCDs.
eXcelon Performance
60
65
70
75
80
85
90
95
100
200 300 400 500 600 700 800 900 1000
% T
rans
mis
sion
Wavelength (nm)
Vacuum WindowTransmission Data
BBAR
UV-AR
VIS-AR
NIR-AR
Uncoated window
NOTE:
Standard anti-reflection (AR) coatings shown. Custom AR coatings and wedge window options are also available. Please contact your local sales representative for more information.
AR COATINgSVACUUm wINDOw
IMAGING GROUP
Page 5 of 7PIXIS: 1024 eXcelon Rev. N2
eXcelon Performance
-4
-2
0
2
4
6
8
10
12
14
350 450 550 650 750 850 950 1050
Wavelength (nm)
QE
Impr
ovem
ent (
B_eX
celo
n -B
)
QE Improvement (B_eXcelon vs. B)
B_eXcelon provides superior QE over the standard back illuminated (“B”) version in the UV-NIR range.
-0.15
-0.10
-0.05
0
0.05
0.10
0.15
600 650 700 750 800 850 900 950 1000 1050 1100
Rela
tive
Am
plitu
deB_eXcelon B
Wavelength (nm)
Etalon Oscillations (B_eXcelon vs. B)
B_eXcelon provides significantly lower etaloning (unwanted fringes) compared to standard back illuminated (“B”) version.
NOTE: QE data @ + 25° C
-5
0
5
10
15
20
25
30
35
40
45
50
350 450 550 650 750 850 950 1050
QE
Impr
ovem
ent (
BR_e
Xcel
on -
BR)
Wavelength (nm)
QE Improvement (BR_eXcelon vs. BR)
BR_eXcelon provides superior QE over standard back deep depletion (“BR”) version over most of the UV-NIR range.
-0.15
-0.10
-0.05
0
0.05
0.10
0.15
600 650 700 750 800 850 900 950 1000 1050
BR_eXcelon BR
Rela
tive
Am
plitu
de
Wavelength (nm)
Etalon Oscillations (BR_eXcelon vs. BR)
BR_eXcelon provides significantly lower etaloning (unwanted fringes) compared to standard back deep depletion (“BR”) version.
NOTE: QE data @ + 25° C
IMAGING GROUP
Page 6 of 7PIXIS: 1024 eXcelon Rev. N2
OUTLINE DRAwINg
PIXIS: 1024 (AIR COOLED)
0
0.23
5.77
11.430.45
54.362.14
47.021.85
12.700.50
0
20.850.82
6.35
0.25
45.2
11.
78
0.23
5.77
0.59
15.0
6
6.53165.75
0
126.114.97
5.97151.70
0
2.1454.43
NOMINAL FOCALDISTANCE ADJUSTABLE
C-MOUNT LENS ADAPTOR
17.530.690
0.48
WINDOW LOCATION
12.19
BE TIGHTENED TO LOCK THE POSITION OF THE LENS
ADAPTOR LOCKING SCREW. 2 PER CAMERAONCE LENS IS IN FOCUS LOCKING SCREW SHOULD
1/4-20 X .25 TAPPED HOLE
C-MOUNT THREAD 1.00 - 32 UNC
4.15105.41
4.65118.11
COOLING AIR EXHAUSTCOOLING AIR INTAKE
NOTES:
WEIGHT: 5 lbs / 2.27 kg 1.
POWER DISSIPATION 80 WATTS AT FULL POWER.2.
AIRFLOW 24 CFM FAN CAPACITY AT FULL POWER.3.
INTERNAL 25MM SHUTTER.4.
M6 THREADED INSERT AVAILABLE FOR CAMERA MOUNTING5.
WINDOW THICKNESS .125" [3.17mm]6.
IMAGING GROUP
Page 7 of 7PIXIS: 1024 eXcelon Rev. N2
www.princetoninstruments.com [email protected]
TOLL-FREE +1.877.474.2286 | PHONE +1 609.587.9797
Visit the Princeton Instruments website to find a representative in your area.
0
2.1454.4
0
1.00-32 UN STANDARDC-MOUNT THREAD
0
0
1.5639.6
1/4-20 UNC
0
0.69
0
CCD
TO
MO
UN
TSU
RFA
CE
17.5
4.35
110.
5
5.20
132.
1
6.53
165.
7
COOLANT INLET/OUT QUICKDISCONNECT FITTINGS
0
0.45011.43
0.50012.70
1.85147.02
0.82120.85
0
0.25
06.
35
1.78
045
.21
0.59
315
.06
0
0.23
5.77
0.23
5.77
9 PIN DINCONNECTORPOWER
2 PIN LEMO CONNECTORSHUTTER
2 MCXCONNECTORS USB 2.0
CONNECTOR
NOTES:
WEIGHT 5.5 lbs / 2.5 kg1.
POWER DISSIPATION 110 WATTS AT FULL POWER2.
INTERNAL 25MM SHUTTER OPTIONAL3.
EXTERNAL WATER CIRCULATOR COOL CUBE II 7567-00024.
PIXIS: 1024 (LIqUID COOLED)
OUTLINE DRAwINg