Protect® 200 Forte
Weight
Weaving count
Breaking strength
Tear strength
Dimensional change
Composition Weave
Cuttable Width Visual
ASTM D-3774
ASTM D-629
ASTM D-3776
ASTM D-3775
ASTM D-5034
ASTM D-1424
AATCC-135
AATCC-61
AATCC-15
AATCC-08
inches
oz / yd2
yarns / inchyarns / inch
NNNN%%
gray scale gradegray scale gradegray scale gradegray scale gradegray scale gradegray scale grade
warp weft warp weft warp weft warp weft
change transference
acid alkaline
dry wet
Colorfastness to crocking
ASTM D-6413
inches
seconds
cal/cm 8.92
Afterflame time
ASTM F-1959
Colorfastness to washing
Colorfastness to perspiration
Characteristics Method Unit Specification
Momentary electric arc (ATPV)*
* Equals Arc Thermal Performance Value. The higher the value, the better the insulation against second degree burn.
C-IFRF200 Rev. 228 Abr 2016
88% cotton / 12% Nylon Twill 3 x 1 “S”
85 +/- 3 44 +/- 2
63 min.
7 +/- 5%
3622052320
minminminmin
+/- 3% 0+/- 3% 0
4 4
3 - 43
4
2
4
minmin
4 minminminmin
max
max
0 0
When washing FR garments, normal washing cycle should be used.
The maximum temperature for drying FR garments is 65 C (149 F).
FR garments should be removed from dryer immediately after they are dry, or slightly moist. Over drying may cause shrinkage.
Steam press or household ironing can be used on FR garments, asit is with cotton clothes.
Neutral soap should be applied for laundering process of FRfabrics.
Chlorine bleach should not be used in the laundering process of FR fabrics, neither by itself nor with other components.
Hydrogen peroxide should not be used on FR fabrics underany circumstance, either separate or as added to a detergent.
For best results when washing and drying the FR garments should be turned inside out during wash and dry.
The maximum temperature for washing FR garments is 50 C (122 F). 0
00
0
NFPA 2112, Standard on Flame-Resistant Garments for Protection of Industrial Personnel Against Flash Fire, 2012 Edition.
inchesTotal Nominal Width ASTM D-3774 65
Body Burn ASTM F-1930 % 9.90
ASTM F 1506, Standard Performance specification for Flame Resistant and Arc Rated Textile Materials for Wearing Apparelfor Use by Electrical Workers Exposed to Momentary Electric Arc and Related Thermal Hazards, 2010a Edition.
ASTM D-6413 /
No ignition, no dripping, no separation 10 %
Flame resistance after 100 cycles of washing and drying
NFPA 2112 Sec. 8.4Heat resistance and Thermal
NFPA 2112 Sec. 8.1
Shrinkage Resistance % Shrinkage max.
CAN/CGSB 155.20 standard on workwear for Protection Against Hydrocarbon Flash Fire, 2000 Edition.