PRR T-1 Duplex Tenderwith Die Cast Body
PRR 13,000 Gallon Tender
HO TENDERS
PAGE 74
#150650 LONG HAUL TENDER
DIMENSIONS:Length 7"Height 1 15/16"Width 2 15/64"
#150660 8-WHEELLONGHAUL TENDER
Our new 7006 Eight Wheel Truck screwsdirectly onto the mounting post in the longhaul tender. (Use 325 screws)
#150681 ELECTRIFICATION KIT FOR MONOGRAM & CON COR 14-WHEEL TENDER
PICK-UP KIT to adapt MonogramModels' 14-wheel Tender for opera-tion behind your Bowser Big Boy orChallenger Tender body is found inMonogram Models' Big Boy Kits#1600, #1601 & #1602. The Pick-Up Kit includes instructions withdrawings; brass wheels with needle-point axles for front truck and brasswheels and bearings for rear trucks;coupler pocket and cover; electricwireless drawbar and weight. Theonly tools required are a knife, file,screwdriver and #43 & #49 drills.
PAGE 75
HO TENDERS
#150690 PRR A-5 SLOPED DECKED TENDER KIT
PAGE 76
5,700 Gallon Sloped Deck TenderDIMENSIONS:Length 3 7/8"Height 1 5/8"Width 1 3/8"
#150001 SP-1 SEMI-VANDERBILT TENDER16,500 Gallon Semi-Vanderbilt Tender
Dimensions: 5 1/32" long x 1 15/32" wide x 2" high
#150032 32' TENDER KITThe 32' tender is the size chosen by the USRA to use behindMikados, Mountains and the light Santa Fe's. It also sawservice behind Pacifics. This little tender is similar tothose used by many roads and they provide an alternative tothe Pennsy styles.
To install Kadee® couplers on the 32' tender, file theintegral coupler box from the underframe and install #5coupler and spring in the cast-on pocket, but it may causea short when double-heading or when coupled to a car withmetal frame and trucks.
NOTE: Use #4224 couplerand #2778 cover with
#256041 screw
HO TENDERS
PAGE 77
PRR T-7 TENDER KIT - with brass sides
This tender is a model of thewelded tender used by the Pennsywith the T-1. The Q-1, S-2 andpossibly one streamlined K-4 usedthe same type tender with a differ-ent deck height, while the S-1 hada similar tender with a greaterwater capacity. These tendersoften saw service behind differ-ent classes of locomotives. Deckheight was adjusted were neces-sary, thus 180 P84 could alsobecome 180 P85 or 180 F75.
Dimensions: 7 1//2" Long x 13/32" x 2 1/16 " high
Pennsy Decal #8001as in photo - not included
in Tender Kit
To install Kadee ® couplers on the T-7 tender, file the coupler box detailfrom the rear sill. Then file a slot inthe bottom of rear casting wideenough to accept the #5 coupler andin- sulated gear box.
PRR HIGH & LOW SIDE TENDERBody castings are not available
PRR LINES WEST TENDER EXTENSION KIT
TIP:If you are having trouble with the electricalpickup from your tender after assembling,check to be sure the Boss on the floor andthe trucks are clean and free of any paint. BOWSER Tender dies have been changed to accept Kadee® #5
coupler or Bowser's #4220 coupler with #4224 coupler pocketand cover #2778.
your existing low side tender body
HO TENDERS