Put the metal point down in the center of your paper and then put the pencil point down. Turn the paper to make the circle.
Draw your design in 1 section. Make sure that you have one thing that stretches from one edge to the other and one thing that is split on the
edge. Then trace onto the tracing paper.
After you trace the design you are ready to transfer it to the next section. Pick the tracing paper up and flip it over.
Lay the tracing paper in the next section and line it up so that it matches the first section. Then trace it again.
The first lines will transfer onto your paper when you trace them. Keep doing that process all the way around. (hint: The last section may not line up perfectly because you are not
perfect. Just line it up the best you can.)