EXTERIOR INSTALLATIONS

D’Iberville City Hall

Crystal Towers, Orange Beach , AL

Lexus Showroom, NHWar Memorial, South Texas

Aurora

INTERIORINSTALLATION

La Costa Spa, California

Disneyland, California

The Nines Hotel, Portland, OR

D’Iberville City Hall

Herman Miller Showroom, Dallas, TX

Crystal Towers, AL

SPECIALTY

Eight Avenue Place Telus Tower, Canada

New York Canterra, Canada

Elevator Floors

A Thin Stone Water Jet Etched, Arizona State University

Hilton University of Houston

Touring Bus

Thin Stone

Premium Natural Stone in Beautiful Colors

•Granite, Marble and Limestone•Kitchen Countertops•Showers•Tub Decks•Flooring•Back Splashes

•Vanity Tops•Natural Stone Tile•Stone Wainscoting•Shaped Trims•Interior Stone Veneers•Elevator Floors

Buckhead, GA

Bella Luna

Bella Luna, Orange Beach, AL

Smyrna, GA

JW Marriot, San Antonio Buckhead, GA

Swabia, AtlantaAlpharetta, Georgia

FABRICATION, SHIPPING AND INSTALLATION PROCESS

FABRICATION

•Blocks of stone usually 5’(W) x 9’(L)x 5’(H) are cut in quarries from around the world and transported to our factory.

•Stone blocks are placed under a sawing machine that cut the block into multiple stone slabs.

•Stone blacks arrive at the factory •Ready for gang sawing

Cont..2

•Rough edges of the slabs are trimmed •Washed•Dried

•The honeycomb backing , fabricated from very thin sheets of aircraft quality aluminum waiting to be epoxied to thin sheets of stone.•Weighs only few ounces per square feet.

•Honeycomb is reinforced on top and bottom of the slab stone by using High Strength Epoxy.•Under extreme high pressure, moved to the press for assurance of complete bonding.

Cont…3

•Right from the center, slabs are split into 2 pieces using large diamond tip radial saw.

•After cutting is complete , panels go for surface finishing.

•As per the requirement of the job, panels are honed or polished.

Cont…4

•Finished panels are then cut into final part sizes, determined by shop drawings.

•Interlocking channels are anchored to backside of the each panel

•Finished panels are marked and numbered based on the shop drawing and are ready to load into crates.

SHIPPING

Step 1

• Pieces are labeled by drawing numbers• Grouped together by floor, unit or color (your choice)

• Custom crates are built for shipping to project site. • Crates are numbered. • Packing list is created detailing crate number, contents and unit.• Crates are loaded on the shipping container.• Packing list is detailed by container number.• Customer gets a copy of the packing list for each container, detailing crate numbers contents, units and quantities.

Step 2

Step 3

INSTALLATIONA lightweight stone installation crew can typically install 25 to 50 panels in a single day. By comparison, a

typical dimensional stone crew may only be able to install 5 to 8 stone panels in a day.