Wall Mount Guitar Holder
This simple wall mount guitar holder is perfect for displaying your guitars without taking up floor space. Simple design
means they look rad even if theres no guitar hung.
Difficulty
Easy
Page 1 of 11
ToolsKreg Tools
Kreg Pocket-Hole Jig® 720
Other Tools
Miter Saw
Scroll Saw
Drill (cordless)
MaterialsWood Products
Board , 1x4 , 12"1
Hardware & Supplies
Pocket Screws 1 1/4"2
2" Black Screws For Mounting2
Ebony Stain1
Satin Clear Coat1
Page 2 of 11
Cut List & PartsWall Mount , 3/4" X 3 1/2" X 5 1/2"1
Guitar Holder , 3/4" X 3 1/2" X 4 1/2"1
Page 3 of 11
DirectionsPlansThese plans illustrate the sizing and cuts for each piece in the holder.1
Page 4 of 11
Cut WoodCut the board (I used maple) into two pieces, one 5 1/2" and one 4 1/2"2
Page 5 of 11
Drill Pocket HolesDrill two pocket holes according to Kreg Jig directions in the longer piece of wood as shown in plans.3
Page 6 of 11
Cut Guitar Neck HoldUse a jigsaw or scroll saw to cut a space for your guitar neck. Cut according to the size of your guitar, making it no larger
than the bottom of the headstock.
4
Page 7 of 11
Attach Wood PiecesUse the pocket hole screws and attach the two pieces of wood as shown.5
Page 8 of 11
Sand, Stain, SealSand, stain and seal your guitar holders. I used Ebony stain and a satin poly.6
Page 9 of 11
Mount to wallUsing wall anchors if necessary, sink two screws through the top half of the wall mount into the wall.7
Page 10 of 11
Page 11 of 11