17 Super Elevation and Spiral Curves

transcript

Superelevation and Spiral Superelevation and Spiral CurvesCurves

CE 453 Lecture 18CE 453 Lecture 18

Objectives1. Define superelevation runoff length

and methods of attainment (for simple and spiral curves)

2. Calculate spiral curve length

Other Issues Relating to

Horizontal Curves 1. Need to coordinate

with vertical and topography

2. Not always needed

MAXIMUM CENTERLINE DEFLECTION

NOT REQUIRING HORIZONTAL CURVE

Design Speed, mph Maximum Deflection

25 5°30'

30 3°45'

35 2°45'

40 2°15'

45 1°15'

50 1°15'

55 1°00'

60 1°00'

65 0°45'

70 0°45'

Source: Ohio DOT Design Manual, Figure 202-1E

Attainment of Superelevation -

General 1. Tangent to superelevation 2. Must be done gradually over a distance

without appreciable reduction in speed or safety and with comfort

3. Change in pavement slope should be consistent over a distance

4. Methods (Exhibit 3-37 p. 186) a. Rotate pavement about centerline b. Rotate about inner edge of pavement c. Rotate about outside edge of pavement

Superelevation Transition Section

• Tangent Runout Section + Superelevation Runoff Section

Tangent Runout Section

• Length of roadway needed to accomplish a change in outside-lane cross slope from normal cross slope rate to zero

For rotation about centerline

Superelevation Runoff Section

• Length of roadway needed to accomplish a change in outside-lane cross slope from 0 to full superelevation or vice versa

• For undivided highways with cross-section rotated about centerline

Source: A Policy on Geometric Design of Highways and Streets (The Green Book). Washington, DC. American Association of State Highway and Transportation Officials, 2001 4th Ed.

Source: CalTrans Design Manual online, http://www.dot.ca.gov/hq/oppd/hdm/pdf/chp0200.pdf

12Source: Iowa DOT Standard Road Plans

Same as point E of GB

Attainment Location - WHERE

1. Superelevation must be attained over a length that includes the tangent and the curve

2. Typical: 66% on tangent and 33% on curve of length of runoff if no spiral

3. Iowa uses 70% and 30% if no spiral4. Super runoff is all attained in Spiral if

used (see lab manual (Iowa Spiral length = Runoff length)

Minimum Length of Runofffor curve

• Lr based on drainage and aesthetics• rate of transition of edge line from

NC to full superelevation traditionally taken at 0.5% ( 1 foot rise per 200 feet along the road)

• current recommendation varies from 0.35% at 80 mph to 0.80% for 15mph (with further adjustments for number of lanes)

Minimum Length of Tangent Runout

Lt = eNC x Lr

• eNC = normal cross slope rate (%)

• ed = design superelevation rate

• Lr = minimum length of superelevation runoff (ft)

(Result is the edge slope is same as for Runoff segment)

Length of Superelevation Runoff

α = multilane adjustment factorAdjusts for total width

Relative Gradient (G)• Maximum longitudinal slope• Depends on design speed, higher

speed = gentler slope. For example:

• For 15 mph, G = 0.78%• For 80 mph, G = 0.35%• See table, next page

Maximum Relative Gradient (G)

Multilane Adjustment

• Runout and runoff must be adjusted for multilane rotation.

• See Iowa DOT manual section 2A-2 and Standard Road Plan RP-2

Length of Superelevation Runoff Example

For a 4-lane divided highway with cross-section rotated about centerline, design superelevation rate = 4%. Design speed is 50 mph. What is the minimum length of superelevation runoff (ft)

Lr = 12eα

Lr = 12eα = (12) (0.04) (1.5) G 0.005 Lr = 144 feet

Tangent runout length

Example continued

• Lt = (eNC / ed ) x Lr

as defined previously, if NC = 2%Tangent runout for the example is:

LT = 2% / 4% * 144’ = 72 feet

From previous example, speed = 50 mph, e = 4%From chart runoff = 144 feet, same as from

calculation

Spiral Curve Spiral Curve TransitionsTransitions

Spiral Curve Transitions• Vehicles follow a transition path as

they enter or leave a horizontal curve

• Combination of high speed and sharp curvature can result in lateral shifts in position and encroachment on adjoining lanes

Spirals1. Advantages

a. Provides natural, easy to follow, path for drivers (less encroachment, promotes more uniform speeds), lateral force increases and decreases gradually

b. Provides location for superelevation runoff (not part on tangent/curve)

c. Provides transition in width when horizontal curve is widened

d. Aesthetic

Minimum Length of Spiral

Possible Equations:Larger of (1) L = 3.15 V3

RCWhere:

L = minimum length of spiral (ft)V = speed (mph)R = curve radius (ft)C = rate of increase in centripetal acceleration (ft/s3) use 1-3 ft/s3 for highway)

Minimum Length of Spiral

Or (2) L = (24pminR)1/2

Where:

L = minimum length of spiral (ft)R = curve radius (ft)pmin = minimum lateral offset between the tangent and circular curve (0.66 feet)

Maximum Length of Spiral

• Safety problems may occur when spiral curves are too long – drivers underestimate sharpness of approaching curve (driver expectancy)

Maximum Length of Spiral

L = (24pmaxR)1/2

Where:

L = maximum length of spiral (ft)R = curve radius (ft)pmax = maximum lateral offset between the tangent and circular curve (3.3 feet)

Length of Spiralo AASHTO also provides recommended

spiral lengths based on driver behavior rather than a specific equation. See Table 16.12 of text and the associated tangent runout lengths in Table 16.13.

o Superelevation runoff length is set equal to the spiral curve length when spirals are used.

o Design Note: For construction purposes, round your designs to a reasonable values; e.g.

Ls = 147 feet, round it toLs = 150 feet.

32Source: Iowa DOT Design Manual

SPIRAL TERMINOLOGY

Attainment of superelevation on spiral

curvesSee sketches that follow:Normal Crown (DOT – pt A) 1. Tangent Runout (sometimes known as crown

runoff): removal of adverse crown (DOT – A to B) B = TS

2. Point of reversal of crown (DOT – C) note A to B = B to C

3. Length of Runoff: length from adverse crown removed to full superelevated (DOT – B to D), D = SC

4. Fully superelevate remainder of curve and then reverse the process at the CS.

http://techalive.mtu.edu/modules/module0003/Superelevation.htm

38Source: Iowa DOT Standard Road Plans RP-2

With Spirals

Same as point E of GB

With Spirals

Tangent runout (A to B)

With Spirals

Removal of crown

With Spirals

Transition of superelevation

Full superelevation

Transition ExampleGiven:• PI @ station 245+74.24• D = 4º (R = 1,432.4 ft) = 55.417º • L = 1385.42 ft

With no spiral …• T = 752.30 ft• PC = PI – T = 238 +21.94

For: • Design Speed = 50 mph • superelevation = 0.04 • normal crown = 0.02

Runoff length was found to be 144’Tangent runout length = 0.02/ 0.04 * 144 = 72 ft.

Where to start transition for superelevation?

Using 2/3 of Lr on tangent, 1/3 on curve for superelevation runoff:

Distance before PC = Lt + 2/3 Lr =72 +2/3 (144) = 168 Start removing crown at: PC station – 168’ = 238+21.94 - 168.00 = Station = 236+ 53.94

Location Example – with spiral

• Speed, e and NC as before and = 55.417º • PI @ Station 245+74.24• R = 1,432.4’• Lr was 144’, so set Ls = 150’

See Iowa DOT design manual for more equations:

http://www.dot.state.ia.us/design/00_toc.htm#Chapter_2

• Spiral angle Θs = Ls * D /200 = 3 degrees• P = 0.65 (calculated)• Ts = (R + p ) tan (delta /2) + k = 827.63 ft

• TS station = PI – Ts = 245+74.24 – 8 + 27.63 = 237+46.61Runoff length = length of spiral Tangent runout length = Lt = (eNC / ed ) x Lr = 2% / 4% * 150’ = 75’Therefore: Transition from Normal crown

begins at (237+46.61) – (0+75.00) = 236+71.61

With spirals, the central angle for the circular curve is reduced by 2 * Θs

Lc = ((delta – 2 * Θs) / D) * 100 Lc = (55.417-2*3)/4)*100 = 1235.42 ft Total length of curves = Lc +2 * Ls =

1535.42 Verify that this is exactly 1 spiral length

longer than when spirals are not used (extra credit for who can tell me why, provide a one-page memo by Monday)

Also note that the tangent length with a spiral should be longer than the non-spiraled curve by approximately ½ of the spiral length used. (good check – but why???)

Notes – Iowa DOT

Source: Iowa DOT Standard Road Plans

Note: Draw a sketch and think about what the last para is saying

17 Super Elevation and Spiral Curves

Documents