Bernard Spinal Alignment Block - Innomed

Post on 14-Nov-2021

2 views 0 download

transcript

Designed by Jason Bernard, MB, MD, FRCS

Bernard Spinal Alignment BlockDesigned to act as a right angle “set square”, using stock sterile rods, to help assess intraoperative mechanical axis of the spine

PRODUCT NO:

5006 Dimensions: 5cm x 5cm x 1cm Rod Holes: 5.5mm, 6.0mm & 6.35mm

Holes of 5.5mm, 6.0mm, and 6.35mm are drilled at right angles through the block on the 1cm high faces. Two sterile stock rods can be inserted into the holes to create the "set square".

MADEIN THE USAPROUDLY

FREE TRIAL ON MOST INSTRUMENTS

1.800.548.2362103 Estus Drive, Savannah, GA 31404www.innomed.net info@innomed.net

912.236.0000 Phone 912.236.7766 Fax

© 2012 Innomed, Inc.

Innomed-Europe Tel. +41 41 740 67 74 Fax +41 41 740 67 71

FREE TRIAL ON MOST INSTRUMENTS

1.800.548.2362103 Estus Drive, Savannah, GA 31404www.innomed.net info@innomed.net

912.236.0000 Phone 912.236.7766 Fax

Innomed-Europe Tel. +41 41 740 67 74 Fax +41 41 740 67 71© 2013 Innomed, Inc.

Scan toLaunch Our

WebsiteISO 9001:2008 • ISO 13485:2003