BMW X6 ActiveHybrid E72 Emergency Responder Quick Reference Guide

Post on 26-Sep-2015

126 views 4 download

Tags:

description

BMW

transcript

  • 1Edition 04/2010 2010 BMW AG Munich, GermanyCopying, reprinting or reproduction, even in excerpt form,requires the written permission of BMW AG Munich.

    Em

    erg

    en

    cy s

    erv

    ice

    s ca

    rd f

    or

    X6

    Act

    ive

    Hy

    bri

    d E

    72

    Legend

    This overview shows the maximum vehicle equipment.

    X6 ActiveHybrid E72(since 10/2009)

    Airbag Bodywork reinforcements

    Airbag control unit

    Gas generator Gas pressure damper

    12-Volt battery

    Belt tensioner Fuel tank High-voltage components

    Special features:

    High-voltage system with DC voltage up to 650 Volts! Do not touch high-voltage components.

    For ActiveHybrid labelling characteristics and details, see reverse!

  • 2Edition 04/2010 2010 BMW AG Munich, GermanyCopying, reprinting or reproduction, even in excerpt form,requires the written permission of BMW AG Munich.

    Em

    erg

    en

    cy s

    erv

    ice

    s ca

    rd f

    or

    X6

    Act

    ive

    Hy

    bri

    d E

    72Labelling characteristics:

    Scoop on the engine compartment lid, see arrow.

    ActiveHybrid logo on the tailgate and front side wall.

    Remarks:

    In accidents where the airbag has been triggered, the high-voltage system is not live.

    12-Volt battery: disconnect the negative pole.

    In accidents where the airbag has not been triggered.

    12-Volt battery: disconnect the negative pole.

    Risk of death!

    Do not touch high-voltage components.

    The high-voltage battery is located under the luggage compartment trim panel.

    Labelling of the high-voltage battery: Labelling of the otherhigh-voltage components:

  • 3Edition 04/2010 2010 BMW AG Munich, GermanyCopying, reprinting or reproduction, even in excerpt form,requires the written permission of BMW AG Munich.

    Em

    erg

    en

    cy s

    erv

    ice

    s ca

    rd f

    or

    X6

    Act

    ive

    Hy

    bri

    d E

    72

    Opening the carThis information applies only to trained rescue workers. An understanding of how safety systems work, along with a knowledge of the cars characteristics, are also required.

    1 The areas mark points at which the roof can be disconnected.Modern high-performance cutters are required for cutting open the bodywork; older hydraulic cutting devices may be insufficient. The high-performance cutters must be used by trained personnel, expertly and properly.

    2 Door locks

    3 Door hinges

    Important informationThe information for relief units must be observed; see Emergency services guidelines, pages 4 - 32.

  • 4Edition 04/2010 2010 BMW AG Munich, GermanyCopying, reprinting or reproduction, even in excerpt form,requires the written permission of BMW AG Munich.

    Em

    erg

    en

    cy s

    erv

    ice

    s ca

    rd f

    or

    X6

    Act

    ive

    Hy

    bri

    d E

    72

    /ColorImageDict > /JPEG2000ColorACSImageDict > /JPEG2000ColorImageDict > /AntiAliasGrayImages false /CropGrayImages false /GrayImageMinResolution 300 /GrayImageMinResolutionPolicy /OK /DownsampleGrayImages true /GrayImageDownsampleType /Bicubic /GrayImageResolution 300 /GrayImageDepth -1 /GrayImageMinDownsampleDepth 2 /GrayImageDownsampleThreshold 1.50000 /EncodeGrayImages true /GrayImageFilter /DCTEncode /AutoFilterGrayImages true /GrayImageAutoFilterStrategy /JPEG /GrayACSImageDict > /GrayImageDict > /JPEG2000GrayACSImageDict > /JPEG2000GrayImageDict > /AntiAliasMonoImages false /CropMonoImages false /MonoImageMinResolution 1200 /MonoImageMinResolutionPolicy /OK /DownsampleMonoImages true /MonoImageDownsampleType /Bicubic /MonoImageResolution 1200 /MonoImageDepth -1 /MonoImageDownsampleThreshold 1.50000 /EncodeMonoImages true /MonoImageFilter /CCITTFaxEncode /MonoImageDict > /AllowPSXObjects false /CheckCompliance [ /None ] /PDFX1aCheck false /PDFX3Check false /PDFXCompliantPDFOnly false /PDFXNoTrimBoxError true /PDFXTrimBoxToMediaBoxOffset [ 0.00000 0.00000 0.00000 0.00000 ] /PDFXSetBleedBoxToMediaBox true /PDFXBleedBoxToTrimBoxOffset [ 0.00000 0.00000 0.00000 0.00000 ] /PDFXOutputIntentProfile () /PDFXOutputConditionIdentifier () /PDFXOutputCondition () /PDFXRegistryName () /PDFXTrapped /False /CreateJDFFile false /Description > /Namespace [ (Adobe) (Common) (1.0) ] /OtherNamespaces [ > /FormElements false /GenerateStructure true /IncludeBookmarks false /IncludeHyperlinks false /IncludeInteractive false /IncludeLayers false /IncludeProfiles true /MarksOffset 6 /MarksWeight 0.250000 /MultimediaHandling /UseObjectSettings /Namespace [ (Adobe) (CreativeSuite) (2.0) ] /PDFXOutputIntentProfileSelector /NA /PageMarksFile /RomanDefault /PreserveEditing true /UntaggedCMYKHandling /LeaveUntagged /UntaggedRGBHandling /LeaveUntagged /UseDocumentBleed false >> > ]>> setdistillerparams> setpagedevice