Post on 13-Oct-2019
transcript
c)
o
FINAL TECHNICAL REPORT September 1, 1994 through August 31, 1995
Project Title: DESIGN AND FABRICATION OF ADVANCED MATERIALS FROM ll..LINOIS COAL WASTES
DOE Cooperative Agreement Number: DE-FC22-92PC92521 (Year 3) ICCI Project Number: 94-1/3. lA-3M Principal Investigator: Viv8.k M. Malhotra, Professor
Southern illinois University at Carbondale Other Investigators: Maurice A. Wright, Director
Materials Technology Center, Southern TIlinois University at Carbondale
Project Manager: . Dr. Dan Banetjee, Illinois Clean Coal Institute
ABSTRACT
The main goal of this project is to develop a bench-scale technology which converts coal combustion residues from TIlinois sources into high-value, advanced composite materials. Pulverized coal combustion (PCC) fly ash (Baldwin), fluidized bed combustion (FBC) fly ash (ADM, Unitsl-6), FBC spent bed ash (ADM, Unitsl-6), and scrubber sludge (CWLP) were characterized for their structural, chemical, and thermal suitability for our composite materials by undertaking scanning electron microscopy (SEM), differential scanning calorimetry (DSC) at 30°C < T < 600°C, differential thermal analysis (DTA) at 50°C < T < 1100°C, and Fourier transform infrared (FTIR) measurements. Our spectroscopic and SEM results indicate that the scrubber sludge is mainly composed of a gypsum-like phase whose lattice structure is different from the lattice structure of conventional gypsum. The sludge does not contain hannebachite (CaS03.0.5~O) phase. The thermal signatures of the residues examined suggest that these coal by-products, when properly combined, can act as excellent raw materials. Besides characterization, we evaluated various variables in the formation of our composites, e.g., fibers, type of coal by-products, admixture and combination of coal residues, binders, and fabrication pressure and temperature. Our data suggest that FBC spent bed ash by themselves are not a suitable raw material for our brake ~hoe pads. However, this is not the case for PCC fly ash particles or for scrubber sludge particles. SEM results on fabricated composites show a lack of cross-linking between carbon fibers and matrix, while this is not the case for slag fibers which showed excellent bonding .. The SEM and Young's modulus analyses of brake composites fabricated at 400 psi < Pressure < 2200 psi imply pressure has a strong influence on the particle packing and the filling of interstices in our materials. On sintering the brake composite, the scrubber sludge derived composite's Young's modulus decreases, while the opposite trend is seen for the PCC derived composite. The Young's (E ) modulus and yield force (F yf) values of our brake shoe pads suggest mechanical behavior better than a high-performance, commercial automotive brake composite.