CREATIVE COMPONENTS FOR THE CAN-AM …lamonster.com/pdf/SPY151.pdfCREATIVE COMPONENTS FOR THE CAN-AM...

harvey@spyderpops.com

Typewritten text

SPY151 - 2014+ RT STAINLESS STEEL (KOTT) GRILLES


Typewritten text

Find the division line between the front nose plastic and the inner


Typewritten text

black duct.


Typewritten text

This is your line to place the plastic screw blocks on by lining them up just to


Typewritten text

the inside of the line and on the duct.


Typewritten text

Below shows you the placement for the


Typewritten text

first screw block as it is centered between the lower black panel and the color


Typewritten text

panel and keeping it attached to the inner duct.


Typewritten text

Now


Typewritten text

place the opposite screw block directly accross from the starter block.


Typewritten text

Repeat on both openings. Place the upper blocks about 1 1/2"


Typewritten text

from the top.


Typewritten text


Typewritten text

Try to balance the blocks from side to side keeping the placement uniform.


Typewritten text

The grilles are a tight fit so use some window cleaner to


Typewritten text

lubricate the rubber seal and this will help you push the


Typewritten text

grilles into place.


Typewritten text

Start installing by placing the top section in first, keeping


Typewritten text

the grille in front of the blocks then swing the bottom down


Typewritten text

and into place against the lower blocks.


Typewritten text

Be sure to push the grilles against the lower blocks before inserting


Typewritten text

the screws. You may have noticed that there are 2 holes in all of the


Typewritten text

blocks and this if for alignment purposes, just choose the one that


Typewritten text

is visable. Put screws in the lower blocks only as the top is wedged


Typewritten text

into place and it will be easy to remove for cleaning. Hold the grille


Typewritten text

against the blocks while installing the screws. Do not over tighten.


Typewritten text

THANKS FOR YOUR PURCHASE, ENJOY THE RYDE!!!!!!!!!!!!!!!!!!!!


Typewritten text

Clean all areas for the stick-on screw blocks


Typewritten text

with isopropal alcohol and let dry. Then use


Typewritten text

the adhesive promotor on the same areas


Typewritten text

and let dry before attaching blocks.

CREATIVE COMPONENTS FOR THE CAN-AM …lamonster.com/pdf/SPY151.pdfCREATIVE COMPONENTS FOR THE CAN-AM...

Documents