Design for disable – toilet details

transcript

05/03/2023

DESIGN FOR DISABLE - TOILET DETAILS 1

DESIGN FOR DISABLE – TOILET DETAILSMUKUND SUTHAR & SAKSHAM GOYAL

05/03/2023DESIGN FOR DISABLE - TOILET DETAILS

AIMAS AN ARCHITECTOUR RESPONSIBILITY IS TO INTEGRATE DISABLE PEOPLE INTO THE SOCIETY IN ORDER FOR THEM TO TAKES AN ACTIVE PART IN SOCIETY AND LEAD A NORMAL LIFE. TO BE ACTIVE, A DISABLE PERSON SHOULD ABLE TO COMMUTT BETWEEN HOME, WORK AND OTHER DESTINATIONS THE TECHNICAL AIM OF THE PRESENTATON IS TO PROVIDE A BARRIER-FREE ENVIRONMENT FOR THE INDEPENDENCE, CONVENIENCE AND SAFETY OF ALL PEOPLE WITH DISABILITY.

IN THE PHYSICAL TERMS, THE PROVISIONAL OF A BARRIAER-FREE ENVIROMENT CAN BE THE UNDERSTAND IN FOUR COMPLEMENTARY DOMAIN :-INSIDE BUILDINGIN THE IMMEDIATE VICINITY OF BUILDINGSON THE LOCAL ROAD AND PATHSIN OPEN AREA AND RECREATIONAL AREAS.

SIGNAGES

SPACE REQUIREMENT

TOILET LAYOUTSOME POINTS TO REMEMBER :- THE MIN. SIZE SHALL BE 1500 X 1750 mm. TURNING CIRCLE OF 1500mm DIA ARE RECOMMENDED

INSIDE THE WASHROON TO ALLOW FOR FULL TURN MOVEMENT OF A WHEELCHAIR.

THE PARALLEL APPOACH, WHICH IS THE EASIEST. THE DIAGONAL

APPROACH. WHICH IS DIFFCULT

TOILET FLOOR SHALL HAVE A NON-SLI SURFACE WITHOUT ANY LVL. DIFFERECE.

GUIDING BLOCK NEAR THE ENTRY SHOULD BE HAVE A TEXTURAL DIFFERENCE, (E.G. DIAMON TILES, PRIMA REGINA TILES, UNDRESSED GRANITE).

LIGHT WEIGHT PVC DOOR SHUTTER SHOULD BE PROVIDED AS A SLIDING DOOR.

PROVISIONAL OF VERTICAL & HORZONTAL RAIL AS 40mm C.P. STEEL PIPE.

TOILET LAYOUT - 1

TOILET DETAIL – DOOR

TOILET DETAIL – HAND RAIL

TOILET DETAIL–WATERCLOSET(WC) FLUSH VALVE IS ON WIDE SIDE OF THE

ACCESSIBLR WATER CLOSET GRAB BARS REQUIRED

TOILET DETAIL–WATERCLOSET(WC)

HEIGHT OF ACCESSIBLE WATER CLOSET SHALL BE 430 – 485 mm MEASURED TO THE TOP OF THE TOILET SEAT.

TOILET DETAILS – SPACE & REACH SPACE ALLOWANCE & REACH RANGES MIN CLEAR WIDTH FOR WHEELCHAIR

PASSAGE – 800 – 1000 mm.

TOILET DETAILS–LAVATORIES&MIRRORS

Lavatories shall be mounted with the rim or counter surface no higher than 850mm above the finished floor Provide a clearance of at least 725mm above the finished floor to the bottom of the apron.

Clear floor space- 750mm X1200mm shall be provided in front of lavatory.

Hot water and drain pipes under lavatories shall be insulated or otherwise configured to protect against contact.

TOILET LAYOUT - 2 ACCESSIBLE TOILET AND SHOWER

COMPARTMENT

TOILET LAYOUT - 2 ACCESSIBLE TOILET AND SHOWER

COMPARTMENT