PARTS SEPARATORKral11l'rllldustril's Inc., Copia~ul', N. Y.

Rotary screen separators from Kramer Industriesoffer complete, rapid separation of parts and me­dia. The openings cannot be blinded by media orparts as would a flat-bed screen. Parts are turnedover to spill out all media. Three sizes are avail­able: the TRS-1 for up to 6 ft:l vibrators; the TRS-2for large vibrators or tumblers; and the TRS-2Dtwo-stage separator for removing fines and sepa­rating at the same time.

Circle 159 on reader information card

SMALL FINISHING SYSTDISAE. Aubin Co., Marlborou~h, Conn.

Aubin's Ty-nee Power Units are the quiet. versa­tile solution to small parts finishing needs. Thevarying shapes and sizes of the barrels and bas­kets allow for a wide range of operations includingcleaning, deburring, separating. stripping, polish­ing. or coating. Both Model 510 and 1600 aredriven by aIlS V/60 Hz electric motor. Model 510weighs only 6 lb with a load capacity of 5 lb. Model1600 weighs 15lb and has a load capacity of20 lb.Each model requires less than 2 ft2 of bench space.

Circle 160 on reader information card

MASS PlNISHINGTurbo-Finish Process Laboratories, Bartlett. N.H.

Turbo-Abrasive Machining and Turbo-PolishingProcesses and Equipment can be used to automatedeburring and edge contour processes on manytypes of rotating components. The process is char­acterized by very rapid cycle times and the abilityto develop sophisticated edge and surface finisheswith a minimum of direct labor and is especiallywell suited to single-piece continuous-flow opera­tions.

Circle 161 on reader information card

December 1999 25