Panelize your PCB

Prof. Andrés Roldánamroldan@ugr.es

Printed Circuit Technology

Open Arduino_GPS.PrjPCBIt is included in the same PDF folder

2.

1.

2. Open the PCB File

3.

To include the OutJOB file in your

PCB projecy you must load the file.

1.

2.

3.

4.

Go to Fabrication Outputs and

Configure the NC drill and Gerber

1.

Select the PCB version you want to export

Configure the export options (Use RMButtom)

2.3.

In the Gerber Setup options

1.

Select ALL Layers

Always use RS274X in your Gerber files

1.

Select Embedded apertures

Go over the advanced options

1.

It is important to know what options has been selected. Other valuesare also possible.

Let’s configure the NC Drill File

1.

It is important to know what options has been selected. Other valuesare also possible.

2. Use RMB

Open the NC Drill Setup Options

1.

In 1. use the higher

resolution available.2.

In 2. you can select any

option.

If you are going to use CIRCUITCAM you have to

remember the chioces you set in these Radio buttoms.

3.

Let’s assign the PATH where these files are

going to be saved.

1.

Let’s assign the PATH where these files are

going to be saved.

1.

Clik the Advanced Buttom

Let’s assign the PATH where these files are

going to be saved.

1.

If you use LMB on GERBER(1.) you can change the PATH

Create a new folder in you PCB Project folderfor all the outputJob you generate.

Now it’s time to Generate the files.

1.

Click on the Generate content arrow.

Follow this procedure with all your OutJob task.

Remember...............

Use this procedure to generate:

1. 3D Videos

2. Print your PDF (SCH and PCB)

3. Export SCH Netlist for outter simulation

4. NC Drils

5. Gerber Files

6. Pick and Place files

7. 3D Prints (Top & Buttom)

8. Final Artworks print

Follow this procedure with all your OutJob task.

You can generate Reports, Validation and

Export outputs in a simple way.

Follow this procedure with all your OutJob task.

1.

2.

3.

4.

Once you have run all

the OutJob, the

CamTastic file has been

created..

You will access to this window.

1.

2.

You can start the Panalization processTools Panelize PCB

1.

2.

Select the PCB you want to panelize.

Introduce the panels sizeUse RMB

1.

2.

Panel Size and spacing data

Panelization results

1.

TH

AT

’s ALL F

OLK

S !