The first model I made was the e6 radio logo using the template from Moodle, after that I dragged it in to model from Illustrator which gave me a flat version of the logo, I then proceeded to extrude it out to make it 3D and the did some bevelling around the edges so that it looked smoother.

After I made the logo I began to make the RADIO part, I did this the same way I did the e6 logo and made the to look almost the same as the e6 logo but with a different colour.

After that I put them bother together and put them in the place I wanted them to be at the end of the animation so that I could work back and not have to try and make it fit together.

After that I began to work on the back ground of the shot, the back ground of the clip is going to be a building entrance for a building called radio 6.

After I made the building I began to work on the doors, the doors have a metal rim around it and glass in the middle.

At the end I placed everything in the right place that I wanted them to be in at the end so that I could work backwards to make it easier to get everything in the ending spot.