Fabrication GuideTriten Range Of Products

Cutting

Four Methods Of Cutting• Plasma Arc• Water Jet• Carbon Arc• Abrasive Saw

• NOT by oxy-gas

Plasma Arc Cutting• Recommended method.• Material can be cut with

hand-held model (inexpensive)

• Plates can be cut from either side

• Consider plasma arc taper

• High definition plasma for greater precision

• Angled torch for countersunk holes

Cold Forming

Material can be pressed or rolled with care

Cold Forming• Rolling always in the

same direction as the overlay beads.

• Convex recommended• Concave with great

care

• Pressing always with a radiused tool, never with a “knife”

Fixing Holes

Methods of attachment• Material cannot be

mechanically drilled or countersunk using traditional methods

• Either :– Plug welding– Stud Welding– Countersunk bolts– Pre-machined inserts

Fixing Holes• Direct plasma arc

piercing gives a perfectly acceptable hole quality for most applications

• A machined insert can be welded in place but is often a more expensive method

For further information, refer to the Triten Fabrication Guide