YuYao Yugao Plastic Mould Co., LTDSkype: tonny—leeEmail: yugaomould@gmail.comWeb: www.yugaomould.com

C265 C266 part is Audi Q3 B Pillar decorate plate. The firstmolding is ABS，the second time molding is PMMA. The followingis the Cavity first molding and second molding.

PMMA ABS

Core and cavity material:M303

High Gloss Mould

The first time is ABS plastic

The second moldingPMMA plastic.

C265 C266 part is Audi Q3 B pillar decorate plate. The firstmolding is ABS plastic，the second molding is PMMA plastic.

Mould on ENGEL_duo900WP machine

First inject isABS, sequence hotrunner molding

Second inject isPMMA,common hotrunner molding

Two same core

Inject ABS oncavity

Inject PMMAcavityAfter finish inject ABS, two

cores rotate 180°withmachine, then inject PMMA.

SANTANA-NF-Gloss B pillar

Part plastic：PMMA Cavity and Core:1.2343(Plating surface）

SANTANA-NF-Gloss B pillar

Auto lamps Mould

VALEO LAMPS

Material：PPT40 Cavity and core:1.2711

VALEO LAMPS

Valeo LAMPS

Plastic：PC Cavity and Core:1.2343

Valeo lampls

IMD Mould

RENAULT part，IMD molding

Plastic：ABS PC Cavity and core:1.2343

RENAULT part，IMD molding

Volvo S60 center console panel,IMD molding

Plastic：PA6GF30 Cavity and core:1.2738

Volvo S60 center console panel,IMD molding

B8PA Interior ,IMD molding

Plastic:PA6 GF35：Cavity and core:NAK80

B8PA Interior,IMD molding

Double Color Mould

Car Spoiler, double color molding

Cavity and core:P20

PP TD20

TPE

Car Spoiler, double color molding

B753 windscreens retaining bar,double color molding

Plastic：PPGF30 + TPE Cavity and core:1.2738H

TPE

PPGF30

B753 windscreens retaining bar,double color molding

Interior and exterior trim mould

Car Mould

Plastic：PPC Cavity and core:718

Car Mould

Renault Panel

Plastic：PE Cavity and core:1.2738

Renault Panel

Renault Panel

Car Mould ，Child Chair

Plastic：PP Cavity and core:718H

Car Mould ，Child Chair

SANTANA Door

Plastic: PP Cavity:718 Core：P20

SANTANA Door

SANTANA Door

NISSAN Grill

Plastic ：2738HH Cavity and core :ASA

NISSAN Grill

NISSAN Grill

RENAULT DRAWER LID

Plastic：2738 Cavity and core:P/E EPDM T15

RENAULT DRAWER LID

Peugeot Part

Plastic：2738 Cavity and core:PP GFHM 40

Peugeot Part

Spare parts and steel are purchased from at home and abroad , thesteel suppler are:Aubert&duval,Assab, HitachiMetals,Bohler,Buderus,Schmiedwerke Grodits

Purchase

Mould base and stander d partssuppliers: LKM，HASCO，LKMRABOUDIN

PurchaseThe hot runner suppliers: HRSMOLDMASTER,Synventivec,YUDO, HASCO,ORMYO,Runipsys