1 cm
1 inch
©2019 Not for commercial use
1:100 Scale
SpaceX Starship Hopper
©2019 Not or
Print on plain Paper
Pod 1-2
Pod 3-4
Pod 5-6
Pod 7-8
These parts are to be printed on plain paper and to be glued on top of the same drawing art on the tankif you decide to update your already built model.
With these parts you will be able to replacethe simple thruster pods that originallywere drawn on top of the tank replacing them with more detailed thruster pods.
1 cm
1 inch
©2019 Not for commercial use
1:100 Scale
SpaceX Starship Hopper
©2019 Not or
Print on Cardstock (110 lbs)
Pod 1-2
Pod 3-4
Pod 5-6
Pod 7-8
1 cm
1 inch
©2019 Not for commercial use
1:100 Scale
SpaceX Starship Hopper
©2019 Not or
Print on Cardstock (110 lbs)
Thruster Pods
Pods 1-2-3-4 Pods 5-6-7-8
©2019 Not for commercial use
Print on Cardstock (110 lbs)
1:100 Scale
1 cm
1 inch
SpaceX Starship Hopper
Formers for body
cut
cut
cut
cut
Top
Bottom
IMPORTANT
Top former is glued 10 mm from top edge of tank.Bottom former is glued 53 mmfrom bottom edge of tank.
©2019 Not for commercial use
1:100 Scale
1 cm
1 inch
SpaceX Starship Hopper
Legs
Print on Cardstock (110 lbs)
Front “�n” leg
Front “�n” leg only
1 cm
1 inch
©2019 Not for commercial use
1:100 Scale
SpaceX Starhopper
©2019 Not or
Print on Cardstock (110 lbs)
“Green” walls are glued last
Bottom DomeStructure
©2019 Not for commercial use
RaptorEngine
The bottom ring is gluedon top of this part, by carefullyaligning the small squares (*) with the three asterixs (*).These asterixs correspond with each leg.
glue
Align with front leg