+ All Categories
Home > Documents > 10 Up Toyota Camry Grille Installation Manual Carid

10 Up Toyota Camry Grille Installation Manual Carid

Date post: 09-Apr-2018
Category:
Upload: enthonytopmak
View: 230 times
Download: 0 times
Share this document with a friend

of 4

Transcript
  • 8/8/2019 10 Up Toyota Camry Grille Installation Manual Carid

    1/4

    http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/
  • 8/8/2019 10 Up Toyota Camry Grille Installation Manual Carid

    2/4

    2 Copyright 2007 by E&G Classics, Inc.

    12 . Install a small black plastic washer and a #8-32ESNA half nut onto each side and bottom stud andtighten.

    13 . Trim the ends from the supplied silicone sleevesand install a sleeve onto each lower mounting stud(all locations).

    14 . Install the supplied upper mounting tabs over thestuds across the top of the grille. Install a #8-32ESNA lock nut onto each stud and tighten. DO

    NOT OVERTIGHTEN or you will indent the sur-round at the stud locations!

    14

    12

    11

    11 . Once the lower grille is installed, align the uppergrille into place, making sure that the sides andbottom studs pass through the slots in the bumpercover.

    7

    7. Use masking tape to tape aroun the upper andlower grille openings.

    8. Before installing the upper grille, align the lowermesh section onto the lower frame. Align thelower mesh grille into place and install it using thesupplied large black plastic washers and ESNA half nuts. You can install the mounting hardware by reaching down from the upper grille opening.

    10 . For SE Lower Installation : You will need to trim aportion off the large black plastic washers in orderfor the washer to seat properly against the back of the factory lower grille insert (as shown). DO NOTOVERTIGHTENthe ESNA half nuts or you willindent the grille surround at the stud locations.You can install the mounting hardware by reachingdown from the upper grille opening.

    10

    9. For SE Lower Installation : Align the mesh sectionand surround into the factory lower grille insert,making sure that the edges of the mesh and sur-round fit inside the factory insert.

    Car Accessories | Toyota Accessories | Toyota Grilles

    http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/
  • 8/8/2019 10 Up Toyota Camry Grille Installation Manual Carid

    3/4

    http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/
  • 8/8/2019 10 Up Toyota Camry Grille Installation Manual Carid

    4/4

    http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/

Recommended