+12v Constant = Blue/Yellow +12v Acc. Switch = Gray -12v Chassis Ground= Brown +12v Illumination = Green +12v Dimmer =Antenna/Amp Remote = Black/Red or Pink/Blue Can-Bus = LF+ = Pink
LF- = Purple RF+ = Lt. Green RF- = Blue LR+ = Black LR- = Yellow RR+ = Red RR- = White
Dash Type : Double DinAftermarket: Single/Double DinKit: TA2055BHarness: TA02BAntanna: Std. Motorola
About the Vehicle
Make: ToyotaYear: 2006-09
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
2006-09
NOTES
Dimensions:
Dimensions: W= L= D=
NOTES
Lower Door: 6.5'' MidrangeSpeaker Adapte: SAT6Speaker Harness: TBAFactory Assembly: (3) rivets securing speaker.
Standard/Optional
Six Disc In-Dash CD changerMP3/WMA PlayerJBL Sound System (Includes 8'' Subwoofer)Auxilary Input
W= L= D=
Type: JBL Audio System Location: Dash Cavity
Speaker Sizes
When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.
Upper Door: 2'' TweeterLower Door: 6.5” MidrangeSpeaker Adapter: SAT6Speaker Harness: TBAFactory Assembly: (3) rivets securing speaker.
When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.
*The vehicle researched was equippedwith the factory JBL Sound System.
Toyota Rav 4
2006-09Toyota Rav 4
Images
Front Speakers
Rear Speakers
Radio removal
Front Speakers
Rear Speakers
1. Using a panel removal tool remove both left and right panels located on each side of the radio.2. Remove the (4) 10mm bolts securing the radio to the dash. Disconnect and remove.
Radio
Door Tweeter
Recommended: Disconnect negative battery cable
Door Speakers1. Using a PRT remove the side mirror panel.2. Using a PRT remove the front of the arm rest handle. Extract (2) PHS from behind the panel.3. Using a small hook tool remove the screw cover inside the door release handle. Extract (1) PHS from behind the cover.4. Using a small hook tool remove the switch panel. Start from the front and lift straight up to release. Disconnect and remove.5. Using a PRT remove the door panel.6. Drill out (3) rivets securing speaker adapter to the door steel. Disconnect and remove.
Door Speakers1.Using a PRT remove the front of the arm rest handle. Extract (2) PHS from behind the panel. 2. Using a small hook tool remove the screw cover inside the door release handle. Extract (1) PHS from behind the cover.3. Using a small hook tool remove the switch panel. Start from the front and lift straight up to release. Disconnect and remove.4. Using a PRT remove the door panel.5. Drill out (3) rivets securing speaker adapter to the door steel. Disconnect and remove
Subwoofer
Tailgate Subwoofer (JBL System Only)1.Using a PRT remove trim panel above rear tailgate window.2. Using a PRT remove trim panels on each side of the rear tailgate window.3. Using a PRT remove tailgate door panel. Disconnect and remove.4. Drill out (4) rivets securing subwoofer to door steel. Disconnect and remove.
Note: The vehicle researched was equipped with the factory JBL Sound System.