+12v Constant = Blue/Yellow +12v Acc. Switch = Gray -12v Chassis Ground= Brown +12v Illumination = Green +12v Dimmer =Antenna/Amp Remote = Black/Red or Pink/Blue Can-Bus = LF+ = Pink

LF- = Purple RF+ = Lt. Green RF- = Blue LR+ = Black LR- = Yellow RR+ = Red RR- = White

Dash Type : Double DinAftermarket: Single/Double DinKit: TA2055BHarness: TA02BAntanna: Std. Motorola

About the Vehicle

Make: ToyotaYear: 2006-09

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Rear

2006-09

NOTES

Dimensions:

Dimensions: W= L= D=

NOTES

Lower Door: 6.5'' MidrangeSpeaker Adapte: SAT6Speaker Harness: TBAFactory Assembly: (3) rivets securing speaker.

Standard/Optional

Six Disc In-Dash CD changerMP3/WMA PlayerJBL Sound System (Includes 8'' Subwoofer)Auxilary Input

W= L= D=

Type: JBL Audio System Location: Dash Cavity

Speaker Sizes

When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.

Upper Door: 2'' TweeterLower Door: 6.5” MidrangeSpeaker Adapter: SAT6Speaker Harness: TBAFactory Assembly: (3) rivets securing speaker.

When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.

*The vehicle researched was equippedwith the factory JBL Sound System.

Toyota Rav 4

2006-09Toyota Rav 4

Images

Front Speakers

Rear Speakers

Radio removal

Front Speakers

Rear Speakers

1. Using a panel removal tool remove both left and right panels located on each side of the radio.2. Remove the (4) 10mm bolts securing the radio to the dash. Disconnect and remove.

Radio

Door Tweeter

Recommended: Disconnect negative battery cable

Door Speakers1. Using a PRT remove the side mirror panel.2. Using a PRT remove the front of the arm rest handle. Extract (2) PHS from behind the panel.3. Using a small hook tool remove the screw cover inside the door release handle. Extract (1) PHS from behind the cover.4. Using a small hook tool remove the switch panel. Start from the front and lift straight up to release. Disconnect and remove.5. Using a PRT remove the door panel.6. Drill out (3) rivets securing speaker adapter to the door steel. Disconnect and remove.

Door Speakers1.Using a PRT remove the front of the arm rest handle. Extract (2) PHS from behind the panel. 2. Using a small hook tool remove the screw cover inside the door release handle. Extract (1) PHS from behind the cover.3. Using a small hook tool remove the switch panel. Start from the front and lift straight up to release. Disconnect and remove.4. Using a PRT remove the door panel.5. Drill out (3) rivets securing speaker adapter to the door steel. Disconnect and remove

Subwoofer

Tailgate Subwoofer (JBL System Only)1.Using a PRT remove trim panel above rear tailgate window.2. Using a PRT remove trim panels on each side of the rear tailgate window.3. Using a PRT remove tailgate door panel. Disconnect and remove.4. Drill out (4) rivets securing subwoofer to door steel. Disconnect and remove.

Note: The vehicle researched was equipped with the factory JBL Sound System.