220kW ELECTRIC HYDRAULIC POWER UNIT—SAFE AREA

Brimmond Group’s 220kW electrically driven HPU can be used either onshore or offshore to provide hydraulic power to a variety of connected equipment such as: Brimmond Group offers a range of complimentary equipment for rental; contact our hire team to find out how we can help you. For special projects, we offer a bespoke design solution, tailored to your requirements.

• Hydraulic spoolers/reelers • Cranes

• Divers tooling • Winches

• Hydraulically driven pumps • Hydraulic flushing units

WORK AREA CLASSIFICATION

For Safe Area Use Only

TECHNICAL SPECIFICATION – STANDARD SUPPLY Motor Type Baldor 300HP / 220kW Electrical Requirements 380 - 480V, 3 Phase, 50/60Hz (220kW @ 60Hz) Starter Star Delta Pump Type Parker Denison P24 Pump Output (maximum) 500 l/min, 350 bar Filtration 90 micron suction, 3 micron pressure, 20 micron return Oil tank Capacity 1000 litre Oil Type Goldline HPX BIO 46

Hydraulic Connections

Main Pump: Pressure A: 1 ½” Pressure Snap-Tite 75 Series Male (threaded) Pressure B: 1 ½” Pressure Snap-Tite 75 Series Female (wing) Case Drain: ½” ISO Type B Flat Face Auxiliary Pump: Pressure: ¾” ISO Type B Flat Face Case Drain: ½” ISO Type B Flat Face

Cooler Blast air cooler

Control Panel

Local: Emergency Stop Hydraulics Start Hydraulics Stop Load / Unload Pressures

Remote: Emergency Stop Hydraulic Flow Hydraulic Pressure Hydraulic Control

Deck Cable 20 metres (when new) Remote Control Panel 20 metres

Moving & Handling DNV 2.7-1/EN12079 certified frame 5-leg certified sling set Forklift pockets

Deck Fastening ISO Container Corners Dimensions 2990mm (L) 2470mm (W) x 2670mm(H) Weight Gross 10,000 kg

All information is correct at the time of printing. Brimmond Group reserves the right to make any changes to the above specification, without prior notice, with no impact on the overall unit performance.