Date post: | 29-Mar-2015 |
Category: |
Documents |
Upload: | kate-lansdale |
View: | 226 times |
Download: | 0 times |
2N® - NETSTAR, Technical Presentation
• 2N NETSTAR is a communication system that integrates well-proven ISDN technologies with advanced GSM and VoIP communication networks.
• The implementation capacities of the 2N NETSTAR system cover a wide range of customer applications for interconnection of communication channels into a single converged network, from transition from the ISDN to multiple providers‘ GSM networks via ISDN and VoIP interconections to three-way interconnection of ISDN, GSM and VoIP networks with a capacity that is sufficient for large corporations.
• The transition between networks is based on a powerful dynamic Least Cost Router (LCR), which automatically chooses the most efficient route to the required destinations.
2N® - NETSTAR, Technical Presentation
- Digital PBX for medium-size clients
- Modular concept with up to 424 ports
- Digital and packet call connection => support of IP clients
- Integrated set of company communication applications
- Support of standard telecommunication interfaces and signalling
- Standard IT interface (XML)
- Web user interfaces
- Set of uniformly designed terminals
- Accessories (surge protection, communicators,
GSM gateways…)
- 8 types of terminals
2N® - NETSTAR, Technical Presentation
Basic Technical Specification
ISDN PRI - 1 to 13 NT or TE ports
ISDN BRI - 4 to 72 ports
FXO - 4 to 212 input analog lines
FXS - 4 to 424 analog subscriber CLIP lines
UPn - 4 to 72 digital (key) subscriber lines
GSM - 1 to 212 ports
2N® - NETSTAR, Technical Presentation
2N® - NETSTAR, Technical Presentation
Basic Technical Specification 2
- AUDIO-RELAY - 4 to 212 AUX ports + 8 to 224 relays- VoIP module : 30 simultaneous calls with codec G.711,
10 simultaneous calls with G.729, GSM
and 8 calls with iLBC
- Installation into a 19" rack, or a stand-alone frame- Extendable by up to 4 units- 110-230V 50-60Hz /150W mains supply per unit- Standard UPS back-up
System Modularity- 72 to 424 ports !
- Basic unit + up to 4 extender units
3U
15U
9U
2N® - NETSTAR, Technical Presentation
Basic Unit
- CPU card
- Switch card
- 3 system slots with data bus
- 9 line card slots
72 ports for an arbitrary, preferably digital line interface
2N® - NETSTAR, Technical Presentation
Extender Unit
- Extender controller card (8-bit CPU)
interconnected with Switch card in the
basic unit
- 11 card slots for analog and GSM cards
up to 88 ports
2N® - NETSTAR, Technical Presentation
Hardware Supported in Units
Basic unit - up to 72 digital ports - ASL,ACOL,DSL,BRI,PRI,GSM, AUDIO-RELAY
Extender units - up to 4 units - 88 analog ports - ASL,ACOL,GSM,AUDIO-
RELAY
Non-backed-up power supply - 110V to 230V - 150W per unit
2N® - NETSTAR, Technical Presentation
Types of CardsCPU cardSWITCH card - 1 PRIPRI card - 1, 2 and 4 PRIBRI - 8 BRIDSL card - 8 UPnCOMBO - 4 BRI and 4 UPnASL - 8 ASLACOL/ASL - 4 ACOL and 4 ASLAUDIO-RELAY - 4 contacts and 2 audio (stereo)
+ same level 4 contacts and 2 audio
2N® - NETSTAR, Technical Presentation
CPU Card- 32-bit control processor
- OS Linux
- Ethernet 100 baseTx, 802.2
for LAN connection [NETSTAR Administrator]
- 1 RS232 [system console]
- support of LAN-to-MMC firmware upgrade
- 1 MMC card slot [MMC v 1.4] for LOG files, Trace files, accounting files
2N® - NETSTAR, Technical Presentation
Switch Card
- 512 x 512 digital switch matrix
- Auxiliary control processor
- 4 interconnections with extender units
total of 8Mbps
- 1 PRI interface / PRI licenced
- RJ45 connectors
Version 1 : Switch card with PRI
Version 2 : no interconnection with extender unit
2N® - NETSTAR, Technical Presentation
PRI Card- Modularity
1, 2 and 4-port versions
- Up to 3 cards in the basic unit
- TE/NT configuration
HW jumper setup
- Master/slave synchronisation
- Signalling DSS1
- CRC support
- RJ45 connector
2N® - NETSTAR, Technical Presentation
BRI Card- Modularity
8 ports - four-wire interface
- Interface configuration LT-T or LT-S
- Port configurationP-P or P-MP
- Signalling DSS1
- Power supply phantom – 48V
- RJ45 connectors
2N® - NETSTAR, Technical Presentation
DSL Card- Two-wire UPn interface
- CORNET proprietary protocol
- CLIP function
- Power supply – 48V
- RJ45 connectors
- 2N StarPoint telephones
2N® - NETSTAR, Technical Presentation
ASL Card- Two-wire interface
- CLIP function
with FSK, DTMF signalling
- Line status signalling
polarity reversal
- Power supply - 48V
- RJ45 connectors
- Line load diagnostics
2N® - NETSTAR, Technical Presentation
4ACOL/4ASL Card- 4 input analog CO lines
- Automatic fall-back to 4 subscriber lines (SL) in case of power
failure
- CO line calling line identification
- CLIP function
with FSK, DTMF signalling
- Line status identification
polarity reversal
- RJ45 connectors
2N® - NETSTAR, Technical Presentation
GSM Card- Versions: 1, 2 and 4 GSM modules
- Supported networks [850/900/1800/1900 MHz]
- Voice support
- Transmitted power: 1 - 2W
- Sensitivity: -104 dBm
- SIM card [small 3V]
- Antenna connector
SMA - impedance of 50 Ohm
2N® - NETSTAR, Technical Presentation
AUDIO-RELAY Card- 4 contacts and 2 audio (stereo)
- 8 contacts and 4 audio (mono)
- TTL logic
0-5 V logic on the output
- Switching relay
pulse length selection
on/off
2N® - NETSTAR, Technical Presentation
Terminals- Analog
pulse and DTMF dialling
- Analog with CLIP reception
FSK and DTMF signalling
- DECT cordless telephones
- ISDN telephones
- Key phones
- IP phones
- SW phones
2N® - NETSTAR, Technical Presentation
2N StarPoint Digital Terminals
- Two-wire key phones with CORNET protocol - Telephones with a wide range of user services- Equipped with an alphanumerical LSD - Function buttons with LED signalling- Full-duplex Handsfree with echo suppression- Extender unit interfaces
Types2N StarPoint Advance2N StarPoint Standard2N StarPoint Economy2N StarPoint Entry
2N® - NETSTAR, Technical Presentation
Button Functions:- Dialling- MUTE- FLASH (hold)- REDIAL- Intercom- Handsfree- Escape- Telephone directory (list)- Missed calls- Outgoing calls
- Received calls
2N® - NETSTAR, Technical Presentation
2N StarPoint SIP Terminals - Ethernet 100 Base-T / SIP
- Smart design
- Function buttons with LED signalling
- Extender unit interfaces
- Full-duplex Handsfree with echo suppression
- Equipped with an alphanumerical LSD
2N® - NETSTAR, Technical Presentation
2N Star SoftPoint SW Terminals - software client for a PC
- SIP
- 2N licence
- Codecs G.711,G.729 ,G.723
- Telephone directory (list)- List of missed, outgoing, received calls
- Echo suppression
- Call redirection
2N® - NETSTAR, Technical Presentation
NETSTAR Assistant- A private www page for every user
- Helps configure service profiles
- Terminal settings
- Call history
- Telephone directories
- CTI phone
2N® - NETSTAR, Technical Presentation
NETSTAR Administrator
- An offline configuration tool
- LAN-based configuration option, profile saving
- Intuitive configuration
- Firmware upgrade
- Licence update
2N® - NETSTAR, Technical Presentation
System Features- Switch matrix for 128 simultaneous calls at least*
- Internal IVR, creation of own tree
- Virtual PBXs
- Mobility Extension
- Different routers for each station
* The switch matrix processes 256 calls at the same time. These 256 channels are limited to 128 by the connection between the A/D converters and the switch matrix (128 calls from/to PRI).
2N® - NETSTAR, Technical Presentation
System Features
Time conditions - arbitrary number of time conditions - National/bank holidays - holiday selection
DISA- possibility to connect multiple
DISAs to IVR- arbitrary number
Ringing table - routing to: station, user and DISA - time-conditioned router assignment
2N® - NETSTAR, Technical Presentation
System FeaturesUser dialtones and ringing tones
- any number of tables
Telephone directories (lists)
- private groups, users
- creation of own lists
- list editing in NS Assistant
Groups
- defining groups for ringing and ringing take-over modes
2N® - NETSTAR, Technical Presentation
System FeaturesTrunks
- defining trunks for PSTN and PN seizure
- defining trunks for ringing
- strategy selection (linear, cyclic)
XAPI
- XML commands for CTI application control in ASSISTANT
- XML commands for MEFISTO hotel system
- XML commands for IP phones
2N® - NETSTAR, Technical Presentation
System Features
CTI
- application implemented in NS Assistant
IP buffers
- defining IP addresses for accounting line dowloads
- internal AOC server memory for 25,000 records
- memory for 60 accouting records (20 per filter) for each station
2N® - NETSTAR, Technical Presentation
System Services- Call reception
- Call hold – one active call
- Call alternation – two active calls
- Call transfer
- Return to transferred call
- Return of transferred call
- Ringing take-over
- Call parking
- Call unparking
2N® - NETSTAR, Technical Presentation
System Services CLIP
- transfer from ISDN
- transfer from GSM
- transfer within NS
- search of telephone directories for match
CLIR
- set own
- set common
- cannot be disabled
2N® - NETSTAR, Technical Presentation
System Services CPN
- CPN check
- CPN normalizing
Outgoing call
- between any interface
- DTMF and pulse dialling
- dialling restrictions, router settings
2N® - NETSTAR, Technical Presentation
System Services Fast dialling
- router settings
BabyCall
- router settings, instantaneous
2N® - NETSTAR, Technical Presentation
2N® - NETSTAR, Technical Presentation
Any questions?
Thank you for your attention.
2N® - NETSTAR, Technical Presentation