5-axis universal – machining center
Manufacture MATEC
Type 30 L 2000
Year of manufacture 2001
Control HEIDENHAIN – TNC 426
Machine number 341
Travels X - 2.000mm / Y - 600mm / Z - 800mm
Swivel head ± 110°
TECHNICAL DATA
MATEC 30 L
travels X – 2.000mm / Y – 600mm / Z – 800mm
spindle SK 40
drive power 20 kW
speed range 20-15.000 rpm
rapid traverse 30.000mm/min.
feed rate from 1-30.000mm/min.
control HEIDENHAIN – TNC 426
preparation for 5. axis rotary table/dividing attachment inclusive transistor actuator
electronic handwheel HEIDENHAIN
swivel head with 1 degree-division
smallest swivel angle 1 degree (serration)
tool magazine with 48 places
machine positionier size 2.500mm x 650mm
completly constructed with
AMF-accuracy-clamping plates
internal coolant supply 20 bar
Equipment of the machine for the use of tools (DIN 69871-SK 40 form B or VDI 40) with internal coolant
supply through the spindle and the tools.
paper band filter system (fineness 30 my)
- 2. coolant circulation (high-pressure pump 20 bar)
- tank capacity paper filtration system 450 l
2 oil mist extraction units for double-sided filtration and extraction of
oil-/emulsions mist
with a flash point not under 120 degree Celsius
electronic air cleaner IFEV 2000 D with motor and
blower
air performance ca. – 1800 m³/h
number of the cell unit 2 pieces
total power 200 watts
operating voltage 220 V 50/60 Hz
partation wall fort wo-place-system
working area-full enclosure with roof
completely enclosed working area The loading doors are designed so that a loading with a crane in the open state is possible at any time.
chip conveyor with integrated coolant system,
discharge height ca. 850 mm
(strap hinge, unpunched) up to X = 2.000 mm
central oil lubrication system
worspace lighting 2-fold
documentation
operating instructions