+ All Categories
Home > Documents > ABB...(Name and Position, e.g. President, Plant Manager, Chief Engineer) of ABB, Inc (Name of...

ABB...(Name and Position, e.g. President, Plant Manager, Chief Engineer) of ABB, Inc (Name of...

Date post: 01-Feb-2021
Category:
Upload: others
View: 0 times
Download: 0 times
Share this document with a friend
13
Transcript
  • TECHNICAL STANDARDS & SAFETY AUTHORITY 14th Floor, Centre Tower 3300 Bloor Street West Toronto, Ontario Canada M8X 2X4

    Show facsimile of manufacturer's logo or trademark, as it will appear on the fitting, in the space below

    A It 11 1111

    STATUTORY DECLARATION 1 Registration of Fittings

    Keith Babin, Quality Manager

    (Name and Position, e.g. President, Plant Manager, Chief Engineer)

    of ABB, Inc

    (Name of Manufacturer)

    Located at 18321 Swamp Road Prairieville, LA 70769 (225) 673-6100 (225) 673-2525

    I

    (Plant Address) (Telephone No.) (Fax No.)

    do solemnly declare that the fittings listed hereunder, which are subject to the Technical Standards and Safety Act, Boilers and Pressure Vessels Regulation, comply with all of the requirements of ASME B31.3 and B31.1 Standards

    (Title of recognized North American Standard)

    which specifies the dimensions, materials of construction, pressure/temperature ratings, identification marking the fittings and service;

    or are not covered by the provisions of a recognized North American standard and are therefore manufactured to comply with as supported by the attached data which identifies the dimensions, material of construction,

    pressure/temperature ratings and the basis for such ratings, the marking of the fitting for identification and service.

    I further declare that the manufacture of these fittings is controlled by a quality system meeting the requirements of ISO 9001:2008

    which has been verified by the following authority, Det Norske Veritas . The items covered by this declaration, for which I seek registration, are category F - Measuring Devices type fittings. In support of this application, the following information and/or test data are attached as follows: Data Sheets: AT100-EN, AT100S-EN; Drawings: FAB1050, AT100S-0000-1, Calculations: 0119-0001-SAR-0001

    (drawings, calculations, test reports, etc.) _

    Declared before me at A in as the --, - / ) at- 1.5 /-) of MCCA1611 Od the

    4..., 1 2' day of \Sep Fer7t-66c)AD 20 / a-. Commissioner for Oaths:

    4.,, 0. 3 c...-■ k - - (Printed game) ,,,

    C7? (•0A--) --A9 - ok lia/tnqj I tOC-4.--) ..,-■

    (Signature) // 34 7 , Vp 1 a

    ‘(Signature of Declarer)

    , FOR OFFICE USE ONLY To the best of my knowledge and belief, the application meets the requirements of the

    Technical Standards and Safety Act, Boilers and Pressure Vessels Regulation, and

    CSA Standard B51 and is accepted for registration in Category F •

    CSA INTER NATIONAL T.

    REGISTERED ' ,

    CRN: CSA-- 0.F ( 6bILA .5(o

    Registered by -R- enin es Sign- •

    Dated: Prcjil- \ 1 204 ,

    -

    Date Rprt 7 i 2014 NOTE: This re istration ex. res on ' .. •

    178 Rexdale Blvd., Toronto, ON M9W 1R3

    PV 09553 (06/04)


Recommended