Hydrostatic pressure naturally created by water depth makes the Hydrostor Solution one of the cleanest, most economical energy storage solutions available today.
The Hydrostor Technology
The Hydrostor solution is true bulk energy storage that addresses the issues of renewable intermittency, grid load balancing, reserve capacity and peak shaving. Hydrostor’s Advanced-Compressed Air Energy Storage (CAES) technology can leverage both in-ground (e.g., salt dome, mines) and underwater storage solutions.
Utilizing state of the art mechanical and electrical components from some of the world’s leading manufacturers,
our clients receive the comfort and peace of mind that the Hydrostor system will perform admirably for the life of the equipment and is backed by a global service network.
Our projects use drilling systems that minimize environmental disturbance and nearly eliminate the need for off-shore construction, as well as a thermal management system allowing superior capture of heat driving our efficiency even higher.
2 AECOM
As a global leader within the energy industry, AECOM offers integrated services to deliver energy storage projects from concept through to planning and delivery.
Our broad range of project management services, coupled with our technical expertise, allows us to thoroughly plan, develop, and execute environmental reviews, permitting, EPC, and commissioning.
AECOM provides a variety of services required to execute and deliver energy storage projects across the globe. In addition, AECOM has the ability to provide integrated energy solutions which build upon our wide range of solar and wind energy experience. AECOM provides a blend of global reach, local knowledge, innovation, and technical excellence in delivery solutions that create, enhance, and sustanin the worlds’s build, natural, and social environments. Leverage AECOM’s experience and resources in energy storage:
Concept assessment − Site selection − Technology selection − Conceptual design and
system sizing − Grid-interconnect investigation − Risk analysis
Techno-economic assessment − Feasibility studies − Social impact assessment − Cost estimations − Financial modeling − Economic benefit assessment − Ancillary service benefits
Project planning − Planning and permitting − Environmental impact
assessments − Stakeholder management plan − Resource planning − Life cycle analysis − Risk and hazard assessments − Cost assessment
Project management − Construction and site management − Environmental health, and safety
management − Commissioning services − Project reporting and stakeholder
management − Contract management
EPC − Mechanical − Electrical − Civil − SCADA − Grid connection and integration − Transmission and distribution − Water/marine − Fire and safety assessment − Construction and site management − Procurement services − O&M schedules − Operational efficiency
assessments
Complete solutions for our clients
Fully financed turnkey solutions
Full lifetime warranty
Operations and maintenance
services
Sized to meet clients varying requirements
Single contract option
3AECOM
How it worksHydrostor’s Adiabatic Compressed Air Energy Storage solution operates by using electricity to run an air compressor which converts the electrical energy into compressed air. Heat from compression is captured during this step and stored to be used during generation, thus increasing the system efficiency. The system also has the flexibility to incorporate additional heat to further increase roundtrip efficiency. The compressed air stream is pressurized to the same pressure found at depth where the accumulators are located.
The air displaces the water in the accumulators and is held until electricity is needed by the consumer.
To satisfy the need for electricity the Hydrostor system reverses the air flow allowing the weight of the water to force the air back to surface under pressure. At surface the stored heat is added back into the air stream and the heated air travels to an expander which drives a generator efficiently converting the energy in the air back into electricity for the consumer.
Charge and discharge equipment in compact configuration System offers small mechanical foot print
Toronto Island Pilot Facility Land Based Equipment
4 AECOM
Advantages − Fuel free adiabatic-CAES via zero-carbon
process − Utility Scale: 2 MW and up | 10 MWh and up − Long life (30+ years) without performance
degradation − Proven components manufactured
by top global suppliers − Low cost − Chemical free and environmentally friendly − Roundtrip AC/AC efficiency from 60% to 70+% − Less than 2 year project lead-time − Maximum flexibility from decoupled charge
rating, discharge rating, storage capacity − Black start and voltage support − Expandable storage capacity − Excellent reliability − Unlimited cycles
Complete Underwater-CAES system on-shore and off
Adiabatic-CAES system with In-Ground Storage Cavity
5AECOM
ApplicationsIslands committed to fossil fuel independence
− Lower electricity rates through replacement of diesel generation with renewables and storage
− Increase distributed renewable generation with central storage resource for optimized grid and asset management
− Enable renewable energy production up to 100% of capacity
− Load leveling through storage of surplus renewables (e.g. curtailed wind or solar) for discharge during peak demand; reducing maintenance and increasing performance of fossil generators
− Back-up power, black start, and voltage support for grid management and emergency situations
Coastal wind and solar projects
− Time shift generation to maximize project economics and plant utilization
− Eliminate renewable curtailment − Increase project size to allow continued generation even
without sun or wind − Provide 24 hour voltage support and black start
capabilities
Advanced Compressed Air Energy Storage Providing operational and environmental benefits to cities and generating assets
On-demand renewable energy generation plants
− Combined installation of wind or solar generation with storage to supply 100% green electricity
− Renewable power on demand − Lower cost power than diesel − Replacement of fuel shipments, oil storage, and aged
contaminated sites − Baseload or peaking plant designs
Reserve / peaking power in coastal cities
− Urban storage systems offering peak shaving and reserve capacity for utilities and grid operators
− Load shifting to reduce transmission and distribution system congestion during peak periods
− Environmentally clean solution for city located peaking plant
− Provide 24 hour voltage support, black start, and power quality conditioning
©2016 AECOM. All Rights Reserved.
6 AECOM
Underwater-CAES Reference Facility
Project experience
Location Toronto Island, Ontario, Canada
Utility Host Toronto Hydro
Power Rating 660 kW Energy Rating Phased expansion to multi-MWh
Utility-Scale Compressed Air Energy Storage Location Goderich, Ontario, Canada
Owner NRStor Inc.
Power Rating 1.75 MW
Energy Rating 7 MWh
Underwater-CAES Reference Facility Interior-Discharge Equipment
7AECOM
aecom.com
For more information, contact:
Travis Starns Business Development Manager - Energy Storage T 303-740-3856 M 303-305-9936 [email protected]
Request technical information and project pricing at: www.hydrostor.ca
About AECOM
AECOM is built to deliver a better world. We design, build, finance and operate infrastructure assets for governments, businesses and organizations in more than 150 countries. As a fully integrated firm, we connect knowledge and experience across our global network of experts to help clients solve their most complex challenges. From high-performance buildings and infrastructure, to resilient communities and environments, to stable and secure nations, our work is transformative, differentiated and vital. A Fortune 500 firm, AECOM had revenue of approximately $18 billion during fiscal year 2015. See how we deliver what others can only imagine at aecom.com and @AECOM.
P_PT_Hydrostor_20160929 ©2016 AECOM. All Rights Reserved.