4
Basic Embedded Lab Edutech offers a comprehensive lab setup for basic embedded lab featuring ARM? LPC2148 platform along with interfacing options like Micro SD Card, TFT & uchscreen. ARMJ CPU Target Board The Educational Practice Board r ARM? focuses the LPC2148 CPU from NXP. This board is designed to study the basic embedded lab exercises on 32-bit ARM platform prescribed in the university curriculum. Features of Kit • LPC2148 microcontroller • 60Mhz. Max operating speed • 512KB of on-chip flash memory • 32KB of on-chip SRAM + 8KB RAM r USB • 9-volt only operation with supplied AC adapter • On board Power-On LED indication • On board Reset Switch with LED indication • On board Switch r Run/Program mode switching • Two 20 Pin (10x2 header) Connector for total 32 GPIO lines • On board USB Connector r UART0 interface with LED indication • On board DB9 connector for UART0 inteace • On board DPDT switch available r switching between UART0 connector (i.e. USB or DB9 connector). • On board USB for Flashing • On board 3 pin header for UART1 interface • On board MMC/SD card connector available • On board 14 pin (7x2 header) connector r 12 channels On-Chip 10 bit ADC interface • On board 3 pin header for 2 channel On-Chip 10 bit ADC interface Learn, st, Apply Features • Curriculum oriented set of learning resources for ARM7TDMI CPU along with workbook. • Set of Educational Practice Board for ARM? LPC2148 CPU from NXP with on chip 512KB flash memory and 32KB RAM memory. In system programming facility, availability of 1/0 ports, On chip ADC, DAC & RTC. Expansion headers r GPIO, SPI, I2C, interrupt signals, USB flashing facility available. • A set of interfacing options available on All in One General Purpose Board • RTOS port for LPC2148 enabling demonstration of RTOS based experimentation. • On board 6 pin relimate connector r SPI0 Interface • On board 6 pin relimate connector r SSP Interface • On board 4 pin relimate connector r I2C0 Interface • On board 4 pin relimate connector r I2C1 Interface • On board JTAG emulation connector (10x2 pins) • On board 2 pin relimate connector facility available r • On chip 10 bit DAC output • On board 2 pin relimate connector facility available r RTC battery interface • On board test points/ Connector facility available r CAPO and CAP1 peripherals. • On board test points/ Connector facility available r Match0 and Match1 peripherals. • On board test points/ Connector facility available r PWM interface. • On board test points/ Connector facility available r External Interface. • Test points r Power supply signals
![AT91SAM ARM-based Flash MCU · Transceiver DDM MPU N V I C TWD1 TWI1 PDC PWMH[0:3] PWMFI0 PDC UART0 UART1 URXD0 UTXD0 URXD1 UTXD1 SSC Peripheral Bridge PDC PDC 2668 Bytes FIFO USB](https://static.documents.pub/doc/80x56/61203ec94ba8c74d39205472/at91sam-arm-based-flash-transceiver-ddm-mpu-n-v-i-c-twd1-twi1-pdc-pwmh03-pwmfi0.jpg)
