Basic Embedded Lab

Edutech offers a comprehensive lab

setup for basic embedded lab

featuring ARM? LPC2148 platform

along with interfacing options like

Micro SD Card, TFT & Touchscreen.

ARMJ CPU Target Board The Educational Practice Board for ARM? focuses the LPC2148 CPU from NXP. This board is designed to study the basic embedded lab exercises on 32-bit ARM platform prescribed in the university curriculum.

Features of Kit

• LPC2148 microcontroller• 60Mhz. Max operating speed• 512KB of on-chip flash memory• 32KB of on-chip SRAM + 8KB RAM for USB• 9-volt only operation with supplied AC adapter• On board Power-On LED indication• On board Reset Switch with LED indication• On board Switch for Run/Program mode switching• Two 20 Pin (10x2 header) Connector for total 32 GPIO

lines• On board USB Connector for UART0 interface with

LED indication• On board DB9 connector for UART0 interface• On board DPDT switch available for switching between

UART0 connector (i.e. USB or DB9 connector).• On board USB for Flashing• On board 3 pin header for UART1 interface• On board MMC/SD card connector available• On board 14 pin (7x2 header) connector for 12

channels On-Chip 10 bit ADC interface• On board 3 pin header for 2 channel On-Chip 10 bit

ADC interface

Learn, Test, Apply

Features

• Curriculum oriented set of learning resources for

ARM7TDM I CPU along with workbook.

• Set of Educational Practice Board for ARM? LPC2148

CPU from NXP with on chip 512KB flash memory and

32KB RAM memory. In system programming facility,

availability of 1/0 ports, On chip ADC, DAC & RTC.

Expansion headers for GPIO, SPI, I2C, interrupt signals,

USB flashing facility available.

• A set of interfacing options available on All in One

General Purpose Board

• RTOS port for LPC2148 enabling demonstration of

RTOS based experimentation.

• On board 6 pin relimate connector for SPI0 Interface• On board 6 pin relimate connector for SSP Interface• On board 4 pin relimate connector for I2C0 Interface• On board 4 pin relimate connector for I2C1 Interface• On board JTAG emulation connector (10x2 pins)• On board 2 pin relimate connector facility available for• On chip 10 bit DAC output• On board 2 pin relimate connector facility available for

RTC battery interface• On board test points/ Connector facility available for

CAPO and CAP1 peripherals.• On board test points/ Connector facility available for

Match0 and Match1 peripherals.• On board test points/ Connector facility available for

PWM interface.• On board test points/ Connector facility available for

External Interface.• Test points for Power supply signals