INNOVATIVE TIMBER SPECIALISTS

STRUCTURLAM

Changing the way we build.www.structurlam.com

CROSS LAMINATED TIMBERCROSS LAMINATED TIMBERCROSS LAMINATED TIMBERCROSS LAMINATED TIMBER

CrossLam by Structurlam

• Material: SPF, Douglas Fir

• Grade: #2+, J-Grade, Lamstock

• Moisture content: 12 % +/- 2 %

• Bonding adhesive: Purbond - Polyurethane

• Layers: 3, 5, 7 and 9

• Lamella thickness 38mm and 35mm

• Maximum dimensions: 12.2” x 10’ x 40’

Over 200

Cross Laminated timber

projects built in the US and

Canada

Meets Standards:ANSI/APA PRG 320State of Oregon BCD 15-01AWC NDS-2015

2015 IBC & NBC-084-2015ICC ESR March 2016

Structural Strength & Stability

Structural Benefits

•Lower material weight at comparable

strength (6 times lighter than concrete).

•Seismic performance.

•Panels span in both directions.

•Dimensional stability with minimal shrinkage

in building height.

•Versatility and ability to integrate with other

materials.

•Minimal site waste

Environmental Benefits

Negative carbon footprint

Environmental - Carbon Sequestration

A typical 2,400 square

foot wood-frame

residence holds 28.5

tons of carbon dioxide,

roughly equal to

removing a small car

from the roads for

seven years.

Structurlam is a pioneer in linking 3D

modeling to CNC machinery

Mass Timber Construction as a

Customized Kit of Materials

In the past, conventional wood construction consisted of ordering lifts of lumber and bundles of glulam to be framed on-site.

With today’s mass timber construction, the column grid is designed to optimize a timber structure, and every stair opening and doorframe is considered early in the design process well ahead of construction start.

Now, with 3D modeling and CNC framing, every beam, column and panel is custom-designed, produced and CNC framed for a specific location in the structure.

3D Model & CNC Framing

3D Model

Resolve conflicts in the Architectural

and Structural 3D models

Lakeshore Instal lation

CLT Manufacturing

CNC Technology

Shipped to site

FP Innovations US CLT Handbook

www.masstimber.com

CrossLam Design Guide

Typical Panel Connectors

Panel Joint Connection

Panel to Panel Connection

Earth Systems Science Building, UBC

UBC Earth System Science Building

UBC Earth System Science

Building

Roof and floor panel

installation

Elkford Community Center

Wall panels

Schedule – Rapid Assembly

Elkford Community Centre

Elkford Community Centre

Shoreline Medical ClinicShoreline, WA

Crosslam SLT3 panels attached to wide

flange steel beams with screws through the

top flange from below……

The first of three truckloads of panels went

up in 3 hours, 5,000 sq ft.

Shoreline Medical ClinicShoreline, WA

Washington State University

Pullman, WA

Washington State University

Clean Technology Lab

Stanford Energy Center

Cooley Landing Education Center

Rocky Mountain Institute

ZGF Architects

Rocky Mountain Institute

Wood Innovation and Design CentreWood Innovation and

Design Centre (WIDC) Prince George, British Columbia,

Canada

Wood Innovation & Design Center

Wood Innovation & Design Center

Up Next 18 Stories

UBC Brock Commons

Kris Spickler | Heavy Timber SpecialistHeavy Timber Group - Structurlam Products LP

4120 Douglas Blvd. #306-502 | Granite Bay, CA 95746

Office: (916) 797-5588 | Mobile: (916) 759-9320

Email address: kspickler@structurlam.com

website: www.structurlam.com

CrossLamTM by Structurlam