Date post: | 26-Dec-2015 |
Category: |
Documents |
Upload: | augustine-hart |
View: | 214 times |
Download: | 0 times |
D A C C
Dreaming And Challenging Company
- Index
Introduce the Company. What are products company produce. K-1 component What is the autoclave? RTM process Q & A
- Introduce Company.
- Pruducts
High Temperature composite Plane Break Disk - *F-16BLCOK 32 *F-16BLCOK 52
Car - *Carbon-Ceramic Break
- Products.
Flying project. -B767, 787 Bonding component.
-The defense industry project KDX1,2 S2-Glass S2-Ceramic
- Customers.
Product.
K-1 component How to making??? Autoclave!!!
- What is the autoclave?
Autoclave is equipment. Autoclave transformation >> Heat + pressure >> composite
deformation- Very generally deformation process.
-For example) - Many Spun glasses pile up and packing (all of handmade) - autoclave is operate - packing inside is vaccum! and very strong product - If packed spun glasses was created hole, this product is
badness !! so!! This work is very detail.
- How to operate autoclave?
Composite pile up Handling packing and checking vaccum point Connect hosepipe (pipe inspiration air
>>vaccum) Autoclave programming setting(time, pressure
temperature) – many time check pressure!! http://www.youtube.com/watch?v=u4BrWI5Xi0g 4:00
- R T M process
Most plane and high technical composite was used autoclave. That is very expensive and low productivity.
RTM process is 3D-preform pile up and used vaccum pressure. This process is all area join together. So product more stronger and high productivity.
Q & A