DIGITAL KEYPAD
FTK1
Distributed by : Audio Visual Security 10 Sandersons Way Marton Blackpool FY4 4NB
General Enquiries : [email protected] www.audiovisualsecurity.org.uk
Sales Tel No : 01253 791 888 Fax No : 01253 791887 Technical No : 01253 792898
6
lndicator:
#*
Volltage Supply : 12 to 24V AC/DC
Dimensions : 76W x 11H x 18Dmm
Weight : 420g
12V Input:
Stand-By Current : 65mA Relay Contact
Operation Current : 104mA Rated
24V Input:
Stand-By Current : 44.5mA
Operation Current : 71.5mA
Technical Data:
1
1. Make sure the User Code, Auxiliary code and Programming code, are the same length. otherwi se, code entry will not be accepted.
5
Orange No
Brown Reed
No (Lock Out)
Light Blue Com
Com
System Restore
Pink Nc
P.B.
-()
AL Out
12V/24V
NC
COM
-()
12V/24V
Out
Aux
(Lock Out)
(Lock Out)
Purple
Red
Black
Gray
Yellow
Blue
White
Green
Magnetic Door Sensor
Door Release Button N.O.
Alarm
Fail-Secure(NO) Lock
Fail-Safe(NC) Lock
Shielding
Green+Black
Yellow+Black
COM
-()
#*
Ground
White+Black COM
-()
Wiring diagram
2
PSU+ _
Diode or Varistor
A DC power supply is required for Fail-Safe locks
Either Diode or Varistor can be used*
WARNING: After performing the above procedures, the system will delete all user codes, the
programming code and the auxiliary code. The keypad will be restored to its default settings.
[Notes: The default code length of the system is four digits. The code length will be changed
following the programming code length is changed
(1) Program or change the : (Default = 1234)programming Code
MMMM MMMM * 00 "code" # MMMM = Programming Code
code = New (4-8 digits)Programming Code
TTT = 000 (Latch mode)
MMMM MMMM * 58 TTT #
MMMM MMMM * 57 C#
MMM MMMM * 56 TTT#
MMMM MMMM * 55 C#
MMMM MMMM * 54 BBBB#
MMMM MMMM * 53 0#
MMMM MMMM * 53 1#
MMMM MMMM * 52 0#
MMMM MMMM * 52 1#
MMMM MMMM * 51 #
MMMM MMMM * 50 XX #
MMMM MMMM * 40 "code" #
MMMM MMMM * 20 TT #
MMMM MMMM * 6YY "code" #
MMMM MMMM * XX "code" #*
*
*
*
*
*
**
**
*
*
*
*
*
***
**
*
[Notes: to the parameters & user codes, the programming code will not operate the lock.]
Tamper switch has to be closed. The programming code only allows changes
*
3 4