+ All Categories

DriveAP

Date post: 07-Nov-2014
Category:
Upload: flashdomain
View: 839 times
Download: 6 times
Share this document with a friend
Description:
 
8
BB Industry Oy - 1 - 06/22 DriveAP 1.2 & 2.1 DriveWare ®
Transcript
Page 1: DriveAP

© A

BB

Indu

stry

Oy

- 1

-04

/08/

23

DriveAP 1.2 & 2.1DriveWare®

Page 2: DriveAP

© A

BB

Indu

stry

Oy

- 2

-

DriveAP key features

Extremely easy to use

Upload, edit, download program

Possibility to monitor signals on-line

Print documentation

Includes 3 operating modes: Stand alone (no drive connected)

On-line (all changes are written immediately to the drive)

Off-line (upload from drive, edit off-line, download to drive)

Uses DDCS communication

Page 3: DriveAP

© A

BB

Indu

stry

Oy

- 3

-

DriveAP is now available in two versions

DriveAP 1.2 Non used blocks are hidden

Block connection with few clicks

Supports 15 blocks

Factory codes 3AFE64554468 (CD)

3AFE64554476 (CD + PC Card kit)

Page 4: DriveAP

© A

BB

Indu

stry

Oy

- 4

-

DriveAP example 1

User can easily make small changes to basic software Relay output selection list does not contain required setting.

RO1 needs to be energized when “Encoder err” warning is given.

No function blocks are required, just use the pointer.

Page 5: DriveAP

© A

BB

Indu

stry

Oy

- 5

-

DriveAP example 2

A measuring device is connected to AI1 of analogue extension module. Drive must create a warning in case input current goes above 6 mA and a fault if input goes above 15mA.

Page 6: DriveAP

© A

BB

Indu

stry

Oy

- 6

-

DriveAP example 3

Create a function that doesn’t exist in a PC tool Enable DriveWindow to monitor alarm bit from drives status word. Add

following block to e.g. 12 ms cycle time and monitor parameter 84.09 instead of 3.02 (status word).

Page 7: DriveAP

© A

BB

Indu

stry

Oy

- 7

-

DriveAP 2

Totally new block programming tool

All data stored to drives flash memory including block location, comments, symbols etc

Page 8: DriveAP

© A

BB

Indu

stry

Oy

- 8

-

DriveAP 2

With Multi Block Programming Application one is able to locate freely over 200 blocks including I/O blocks (AI, AO, DI, DO, EXT AI, …)

Functions blocks (ABS, ADD, AND, BSET, COMPARE, COUNT, …)

Communication blocks (Profibus, Master/Follower)

Comment blocks

5 pages / time level available

Separate info page describes block functionality

Factory codes 3AFE68299195 (CD)

3AFE68299209 (CD + PC card kit)


Recommended