DSM13 MULTIFUNCTION STEAM MOPINSTRUCTION MANUAL
w w w . v y t r o n i x . c o m
Page 1 of 12
BLANK PAGE
Page 2 of 12
Safety instructions
WARNING:Read all safety warnings and all instructions. Failure to follow the warnings and
instructions listed below may result in electric shock, fire and/or serious injury.
• Warning: When using electrical appliances, basics safety precautions, including the
following, should always be followed to reduce the risk of fire, electric shock,
personal injury and material damage.
• Read all of this manual carefully before using the appliance.
• The intended use is described in this manual. The use of any accessory or
attachment or the performance of any operation with this appliance other than
those recommended in this instruction manual may present a risk of personal injury.
• Retain this manual for future reference.
Safety of others
• If this appliance is to be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, they must be given supervision or
instruction concerning use of the appliance in a safe way and understand the
hazards involved prior to using the appliance to ensure their safety and the safety of
others around them.
• Children must not be allowed to play with this appliance
• The appliance must not be left unattended while it is connected to the mains power
supply.
• The appliance is not to be used if it has been dropped, if there are visible signs of
damage or if it is leaking
• Keep the appliance out of reach of children until it has completely cooled down after
use even once unplugged as steam may still be pressurized inside.
Page 3 of 12
Using your appliance
• Do not direct steam at people, animals, electrical appliances or electrical outlets.
• Do not expose to rain.
• Do not immerse the appliance in the water.
• Do not leave the appliance unattended.
• Do not leave the appliance connected to an electrical outlet when not in use.
• Never pull the power cord to disconnect the appliance from the socket.
• Keep the appliance cord away from heat, oil and sharp edges.
• Do not handle steam cleaner with wet hands.
• Do not pull or carry by cord, use cord as a handle, close door on cord, pull cord
around sharp corners or expose cord to heated surfaces.
• Do not use appliance in an enclosed space filled with vapor given off by oil-base
paint thinner, some moth-proofing substances, flammable dust, or other explosive or
toxic vapors.
• Do not use on leather, wax polished furniture or floors, synthetic fabrics, velvet or
other delicate, steam-sensitive materials.
• Do not use on any unsealed hard floor surfaces. Additionally, on surfaces that have
been treated with wax or some no-wax floors, the sheen may be removed by the
heat and steam action. It is always recommended to test an isolated area of the
surface to be cleaned before proceeding. We also recommend that you check the
use and care instructions from the floor manufacturer.
• Never put detergent or chemical products into the steam mop unless they have
been approved by Vytronix Ltd, as this may damage it or make it unsafe for use.
• The appliance emits very hot steam to sanitize the area of use. This means that the
steam head and cleaning pads get very hot during use.
• Always wear suitable shoes when using your steam mop and when changing the
accessories on your steam mop. Do not wear slippers or open-toed footwear.
• The tank lid may become hot during use.
• Care should be taken when using this appliance. DO NOT touch any parts which may
become hot during use.
• Do not use without the micro-fiber cleaning pad correctly installed.
Page 4 of 12
Box contents
A. Handheld Unit
B. Main Body/Folding Handle
C. Window Squeegee
D. Small Scrub Brush
E. Medium Scrub Brush
F. Accessory Adaptor
G. Angle Nozzle
H. Grout Cleaning Tool
I. Scraping Tool
J. Measuring cup
K. Microfiber Pad
L. Garment Steamer Cloth
M. Steam & Detergent head
N. Carpet Gilder
Product parts
1. Handle Lock Release
2. Handle
3. Power Cord Hook
4. Steam head swivel
5. Lock Catch
6. Power Cord
7. Power Switch
8. Water Inlet
9. Indicator light
10. Steam Adjustment Control
11. Water Tank Cap
12. Water Tank Button
13. Water Tank
14. Detergent Tank
15. Detergent On/Off Control
Page 5 of 12
Technical specification
• Rated voltage: 220-240V
• Rated frequency: 50Hz
• Output power: 1300W (+5%,-10%)
• Water tank capacity: 300 ML
• Steam output time: 20 minutes
• With a ready indicator. when the appliance is connected to power supply, turn on
the power switch, the indicate light will change to blue, meaning the mop is ready to
emit the steam.
• The angle of the rotation axis in the cleaner is greater;
• Comprehensive accessories configuration
Assembly
WARNING: Before attempting any of the following operations, make sure that the appliance
is switched off and unplugged and that the appliance is cold and contains minimal or no
water.
Locking the handle into position / releasing the handle
• To lock the handle into the upright position, simply lift the handle until it clicks into
place. Check handle is secure before using the steam mop.
• To release the handle and fold away for storage, press the release button on the
front of the handle and then gently fold the handle downward.
Page 6 of 12
Attaching the base to the main body
Slide the bottom end of main body
onto the steam head until it clicks into
place.
The steam head can be removed from
the main body by pressing the release
button on the main body.
Attaching a cleaning pad
Simply press the pad onto the underside of the base and it will
stick in place.
To remove the pad simply peel away from the base.
Attaching Carpet Gilder
After attaching a cleaning pad, lay the carpet glider flat on the
floor with the more open side facing upward. The Steam mop
simply snaps into place by pressing it into the carpet glider.
To remove the carpet glider, carefully unhook the securing clips
and the carpet glider will release,
Page 7 of 12
Operation
1) Fill the water tank
Method one:
Open the water tank cap by tuning it counterclockwise, fill
tank with 300ML of water use measuring cup, then
replace cap and turn clockwise to close.
Method two:
Remove the water tank from main body, open the
water tank cap by tuning it counterclockwise, fill
the water tank directly from a tap, then replace cap and
turn clockwise to close.
Place the water tank back into main body until it clicks into
place.
2) If using detergent, open the cap of the detergent tank and add the detergent into
the tank.
3) Plug in the appliance.
4) When the steamer is switched on, the indicator lights will turn red either side of
water tank to indicate it is preheating. If the lights do not illuminate, please check
the "troubleshooting" section for more details.
5) It will take approximately 20 seconds for the steamer to preheat, once the steam
mop is ready to use, the water tank will glow blue and the mop will emit steam
automatically, for this reason it is important not to leave the steamer unattended
while it is pre-heating.
6) To activate the detergent function, you will need to press the on/off button situated
on the base, when on, detergent will automatically me mixed into the steam as it is
emitted.
7) A full tank of water should last approximately 20 minutes.
8) The steam flow rate can be adjusted by turning the steam dial on the main body to
increase or decrease steam intensity depending on the nature of the cleaning task.
Page 8 of 12
To use as a handheld steamer
1) Press the release button on the main body to remove
handheld unit.
2) Install the accessory adaptor to the
handheld unit, this can later be
removed by pressing the release
button.
3) Select the accessory you wish to
use, place it onto the accessory
adaptor and turn clockwise until it
locks into place.
Page 9 of 12
Accessory list
WHAT IT’S CALLED WHAT IT LOOKS LIKE WHAT IT’S FOR
Window Squeegee/Garment
Steaming Tool
Removing soap scum and grime
from shower glass, mirrors and
windows.
Taking creases out of hanging
garments, curtains tablecloths and
more.
Small and Medium Scrub
brushes
Oven, microwaves, stove tops,
showers, bathtubs, tap fixtures,
tile, grout, toys, refrigerators, and
more.
Angled Nozzle
Stove tops, around tap edges,
grout, microwaves, sinks and other
hard to reach areas.
Grout cleaning Tool
Cleaning tile grout.
Scraper Tool
Scraping off baked on food, grime,
and grease. Removing residue or
other difficult substances from
non-delicate surfaces, such as
stove tops and ovens.
Garment Steamer Cloth
To be used with “Garment
Steaming Tool”
Microfiber Pad
(design may vary)
For general cleaning of hard floors
and refreshing carpets.
Page 10 of 12
Cleaning, maintenance and storage
BE SURE THAT THE UNIT IS DISCONNECTED FROM THE POWER OUTLET AND COMPLETLEY
COOLED DOWN BEFORE PERFORMING MAINTENANCE
Drain the remaining water in the tank and rinse after use.
Cleaning attachments can be washed in warm water with a small amount of dish soap if they
become dirty.
How to clean the water tank
To remove water marks and/or calcium deposits that build up inside the water tank, add one
or two tablespoons of white vinegar to a full water tank, replace the tank cap and then shake
the contents.
DO NOT TURN THE STEAMER ON.
How to remove limescale
If your steam mop begins to produce steam more slowly than usual or stops producing steam
completely, it may have a buildup of limescale. Lime scale can develop over time on the
metal parts, especially in hard water areas and can greatly affect performance.
It is advised to remove lime scale on regular basis every approximately once a month,
depending on water hardness and frequency of use.
1. Prepare a solution of 1/3 white vinegar and 2/3 tap water and add to the water tank.
2. Secure and position the unit to ensure steam released is aimed away from the floor or
surrounding objects and surface. Plug the unit in, turn the unit ON by pressing the power
switch, and allow the unit to produce steam until the vinegar/water solution is used up.
3. Repeat the above procedure as many times as necessary until a normal steam flow rate is
achieved.
4. Rinse out the tank thoroughly.
5. Fill the water tank with fresh water, attach to the unit and release steam through the
system until the water tank is empty to completely flush out any residual cleaning solution.
WARNING
Don't leave the steamer unattended during the limescale removal process and/or while in
use.
Perform a test cleaning on a suitable isolated area after each lime scale removal to ensure
that there is no debris left in the system.
Page 11 of 12
Cleaning blocked accessories
Due to the water hardness in some areas, you may notice that less steam comes out from
the handheld steamer accessories, this may be caused by calcium buildup inside the tip of
the accessory nozzle.
How to clean calcium buildup
We recommend using a spray lubricant. Spray a small burst or two of the lubricant inside the
tip of the Jet Nozzle. After spraying lubricant inside the component, fill the steamer with
water according to the filing directions and run a continuous jet of steam through the
affected accessory for several minutes to remove the deposit once the steam pathway is
clear, aim the steamer at a neutral surface or cleaning cloth to make sure no debris is
emitted.
This product contains no serviceable internal parts. Do not try to repair it yourself. Any
maintenance or repair that requires disassembly or any steps other than those stated in this
manual must be carried out or approved by Vytronix Ltd.
Cleaning the microfiber pad
Machine washable on at 30 – 40 degrees. Always use water only or a mild detergent.
For best results, lay flat to dry. Do not tumble dry
IMPORTANT:Never use bleach or fabric softener when washing the microfiber cleaning
pad.
Storage after use
After the steamer is used, switch off the power and then unplug the power cord.
Take out the water tank and empty the residual water and wipe the external surface with a
dry cloth.
Remove the cleaning pad and wash it so that it will be ready for next use.;
Store product in a protected, dry area.
Keep out of reach of children.
Page 12 of 12
Troubleshooting
It is always advised to check the troubleshooting guide in the event of any issues before
making contact with Vytronix Ltd as many issues can be resolved quickly and easily at home.
BE SURE THAT THE UNIT IS DISCONNECTED FROM THE POWER OUTLET AND COMPLETELY
COOLED DOWN BEFORE PERFORMING TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Reduced steam or no steam Water tank may be empty Fill water into the water tank
Steam nozzle may be blocked Clean steam nozzle
There is no power to the unit Make sure unit is plugged in
Steam control Knob is in
MIN.
T Turn steam control knob
C clockwise.
Unit will not turn on
Power cord not plugged in Plug cord into a working
socket.
Internal fuse is blown Replace fuse with
appropriate type.
Warranty Registration
To register you free one year Vytronix warranty visit www.vytronix.com using product code:
brandnew-vytronix-dsm13
Safe Disposal
This marking indicates that this product should not be disposed with other
household waste throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To arrange
safe disposal of your used device, please use the return and collection systems
or contact the retailer where the product was purchased.
Register your warranty at www.vytronix.com