Tail Pitch Slider 01[H0055BM]
Bearing 5x 10x4mm(HC411-S)
Uniball M2.5x 5H6(H0064-S)
Tail Rotor Hub Assembly
Tail Blade GripAssembly
Tail Pitch Slider Link Assembly
Tail Pitch Slider Link Assembly
Tail Pitch SliderAssembly
H08
26M
_rev
01
Tail Pitch Slider Link(H0261-S)
Tail Blade Grip(H0327BM-S)
Flanged Bearing 8x 12x3.5mm
(HC418-S)
Tail Pitch Slider 02(H0407-S)
Spacer 8.1x 9.2x3.2mm
[H0029]
Tail Pitch Slider 03[H0054]
Tail Pitch Slider Assembly
Oring(HC335-S)
Tail Shaft(H0325-S)
Tail Rotor Hub Assembly
Spacer 5x 9x0.75mm(H0330-S)
Thrust Bearing5x 10x4mm
(HC435-S)
Bearing5x 10x4mm
(HC411-S)
Socket Head CapScrew M2x6mm(HC004-S)
Button Head Cap Screw M4x6mm(HC096-S)
Note: Smaller ID
Note: Larger ID
Spacer7.5x 10x0.5mm
(H0349-S)
Socket Head CapScrew M2x6mm(HC004-S)
Spacer2x 3x3mm
(H0076-S)
Note: S >> Left Side
Note: S >> Right Side
Note:It is a normal for the tail to feel a bit tight after initialassembly as the tail spindle preload is ussually high whenthe helicopter is brand new. The preload will loosen upafter 2-5 flights allowing the system to become smooth.
Spindle Shaft(H0329-S)
eg: Microlube GL261
eg: Microlube GL261
TAIL ROTOR [H0826-K]
Please read this user manual carefully, it contains instructions for the correct assembly of the KIT.Please refer to the website www.goblin-helicopter.com for updates and other important information. Thanks You.