BERDAV®marine Husky

Flash Lights Unit (incl. Rescue Step)

Installation Manual

In this manual, we lead you step by step through the installation procedureof the Flash Lights Unit for the Husky.

The whole procedure will be done within a few minutesif you follow this manual precisely.

01)

Rezz your Husky and align it to the grid.Make sure its rotations are 0°/0°/0° (x / y / z - Axis),and find a good number for its position w/o decimals.

See image below.

02)

Now rezz and unpack the [ BERDAVmarine Genuine Parts - Flash Lights Unit (Husky) ] from your inventory folder.We need its content which is

− the Flash Lights Unit− the [ BERDAVmarine Genuine Parts - Control Unit Software (Husky) ]

See image below.

03)

Bring the Flash Lights Unit in position on the boat's roof bar.Make sure both boat and Flash Lights Unit are properly aligned.The Flash Lights Unit is properly aligned when you put following values: boat position X + 0.892boat position Y + 0.000boat position Z + 1.844

See image below.

04)

Link the Flash Lights Unit to the boat.The Husky now is 32 prims.You did well when the name of the linkset says ' * BERDAVmarine Husky ',so the boat stayed root.

See image below.

05)

To recover the Link Order again,which is important for a proper sitting,it is required to unlink following prims:

1 = Seat 02 M Port2 = Seat 02 M Starboard3 = Storage4 = Seat 02 M Stern5 = Rammleiste

(The Soft Top is NOT unlinked or removed, it is just furled for you to bettersee the other prims!)

See image below.

06)

The next step to recover the Link Order is to link the following prims,in the listed order:

5 = Rammleiste4 = Seat 02 M Stern3 = Storage2 = Seat 02 M Starboard1 = Seat 02 M Port

See image below.

Note!Steps 05) and 06) always should be done whenever you touch the boat'slinkset.Remember that many of the boat's prims receive link messages from theboat's master script and may have content which is important for a properoperation of the Husky.The above listed prims 'only' are sit scripted prims.You may unlink, delete and replace them and may skip them when recoveringthe Link Order, but keep in mind that the proper sit behavior may be messed upif you do so.

07)

Now 'open' the entire boat and delete the stock master scriptHusky v1.x in its content.

See image below.

08)

Replace it with the Husky G v1.x script which u find in the[ BERDAVmarine Genuine Parts - Control Unit Software (Husky) ] cardboard box.

See image below.

09)

Rename the entire boat,take it to your inventory andrerezz it.

On touch, the new advanced menu should pop up now.

Find the new buttons 'Flash Lights', 'Siren' and 'Resque Step',which all should work now if you precisely followed this instruction.

See image below.

Note!You may replace the Siren sound in the Flash Lights Unit with any prefered soundas long as you name it 'Siren'.You further may replace the texture in the Flash Lights Unit with any preferedtexture.

BERDAV®marine

http://berdav.com Blake Sea