Ford Kuga AWD Programmable Module Installation Guide
Model:
2008 Kuga
Operation:
Replace the AWD module and input data manually
Conditions and Requirements:
The communication is normal, and battery voltage stable
Software Version
Ford V48.50 or above
Product requirement
X431 PRO series, PAD series products.
Operation Steps:
1. Enter “Ford” software and choose “Auto Search”.
Illustration 1
Illustration 2
2. Confirm the vehicle specification, and choose “Yes”.
Illustration 3
3. Select “Module Programming”.
Illustration 4
4. Select “Programmable Module Installation”.
Illustration 5
5. Select “AWD(All Wheel Drive”.
Illustration6
6. Whether the original mode still available? If we have removed it, please select “No”.
Illustration 7
7. Read the tips carefully, select “manual” when we have replaced by a new module or
original module not available.
Illustration 8
8. Input the VIN code on Ford OEM website to query the original factory data, find the
corresponding section of ‘761-01-01’ and manually enter the data in turn (Illustration 9-1)
Illustration 9-1
Illustration9-2
Illustration9-3
Illustration 9-4
9. Set ignition switch to OFF (position 0).
Illustration 10
10. Input the VIN.
Illustration 11
11. Confirm the VIN right or not.
Illustration 12
12. Install a new module in vehicle.
Illustration 13
13. Turn on ignition.
Illustration 14
14. Wait, communicating…
Illustration 15
15. Succeeded.
Illustration 16