Hamilton Beach 70740 Power CordReplacement

This guide is intended for replacing the ruptured or faulty Hamilton Beach Food Processor 70740Power cord.

Geschrieben von: David Gedeon

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 1 von 8

EINLEITUNG

This guide may be useful for users who are experiencing power issues. This procedure requires ahigh technical skill in electrical soldering, along with moderate electrical wiring skills.

WERKZEUGE:Soldering Station (1)

TEILE:250 Watt power cord replacement (1)

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 2 von 8

Schritt 1 — Base Removal

Hold the food processor upside down and remove the two screws indicated with a screwdriver.Once unscrewed, remove the two rubber suction pads.

Schritt 2

Use a spudger to remove the 4 rubber base pads located at the corners of the device.

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 3 von 8

Schritt 3

Unscrew all 4 screws that arelocated beneath the pads with ascrewdriver and remove the plasticgrey base.

Schritt 4

Remove the screws indicated with ascrew driver.

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 4 von 8

Schritt 5

Remove the two screws behind theknob with a screwdriver.

Schritt 6 — Motor/Cord

Use a regular nylon spudger toremove the plastic caps at theselocations with moderate pressure.

When working with electronics, it'simportant to choose a tool that'sESD-safe to avoid accidentaldamage to the device. The regularblack nylon spudger or a plasticopening tool should be usedwhenever possible.

Apply pressure at the edge of theplastic cap circles. Apply stresselsewhere may damage the device.

Note that the plastic caps are glued

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 5 von 8

Schritt 7

Remove the 4 screws located underthe plastic caps with a screw driver.

Schritt 8

Lift and remove the plastic gears at the center of the device.

Remove any grease residue underneath the plastic gears.

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 6 von 8

Schritt 9

Remove the remaining screws to unhinge the motor located at the center of the device using ascrew driver.

Schritt 10 — Power Cord

Solder the highlighted section of thepower cord, and undo the wiring.Using soldering wire connect a newline with the soldering iron.

Learn more about soldering here.

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 7 von 8

To reassemble your device, follow these instructions in reverse order.

Dieses Dokument wurde zuletzt angelegt am 2017-10-30 06:21:00 AM.

Schritt 11

Connect the other end of your powercord to the motor terminal.

Hamilton Beach 70740 Power Cord Replacement

© iFixit — CC BY-NC-SA de.iFixit.com Seite 8 von 8