+ All Categories
Home > Documents > Hardware Transmit Lockout for the TS-590S and ... - kkn.net

Hardware Transmit Lockout for the TS-590S and ... - kkn.net

Date post: 12-Apr-2022
Category:
Upload: others
View: 6 times
Download: 0 times
Share this document with a friend
2
Hardware Transmit Lockout for the TS-590S and the TS-590SG Steve London, N2IC Locate Q904 on the foil side of the TX-RX board. The TX-RX board is accessed by removing the bottom cover of the TS-590. The board must be removed to access the foil side. In the attached drawings, Q904 is shown, circled in the top, left corner. Connect 2 wires to Q904. One wire to the base, the other to the emitter. To inhibit transmit, short the two wires together using a relay or other means. Do not short either wire to ground. Thanks to E7DX and S55M for this information.
Transcript
Page 1: Hardware Transmit Lockout for the TS-590S and ... - kkn.net

Hardware Transmit Lockout for the TS-590S and the TS-590SGSteve London, N2IC

Locate Q904 on the foil side of the TX-RX board. The TX-RX board is accessed by removing the bottom cover of the TS-590. The board must be removed to access the foil side. In the attached drawings, Q904 is shown, circled in the top, left corner.

Connect 2 wires to Q904. One wire to the base, the other to the emitter.

To inhibit transmit, short the two wires together using a relay or other means. Do not short either wire to ground.

Thanks to E7DX and S55M for this information.

Page 2: Hardware Transmit Lockout for the TS-590S and ... - kkn.net

TS-590S


Recommended