Hollow Rotary Stages SQ-135A V5 1 Square Automation Contact : + 91 965733 2859 (Pune, MH) + 91 98501 72779 Email : [email protected]Web : www.square-automation.net Packaging Rotary Positioning for Welding Vision Inspection Laser Marking Rotary Positioning for Pad Printing Pneumatics Punching Rotary Positioning for Ultrasonic welding Feature Equipped with Stepper Motor or Servo Motor and high resolution drive, working with Motion Controller to achieve automatic control. High precision fit; High load capacity; Long lifetime Worm gear / shaft drive system; Smooth motion Free direct and reverse rotation Ingenious design to minimize backlash Special design to minimize the end runout and off center Step motor and worm shaft connected with high quality elastic coupler to get low noise Synchronous transmission Servo-motor can be used for industrial application SQ-135A Rotary Stage Series offers an unparalleled combination of good accuracy and high load capacity. These rotary stages utilize a precision worm gear with the worm “flexed” against the gear to ensure a proper mesh. This feature provides high repeatability with very smooth operation. Additionally, the rotary stages incorporate an oversized pre loaded cross roller bearing, offering exceptional stiffness and load capacity.
Pneumatics PunchingRotary Positioning for Ultrasonic welding
Feature
Equipped with Stepper Motor or Servo Motor and high resolution drive, working with Motion Controller to achieve automatic control.High precision fit; High load capacity; Long lifetimeWorm gear / shaft drive system; Smooth motionFree direct and reverse rotationIngenious design to minimize backlashSpecial design to minimize the end runout and off centerStep motor and worm shaft connected with high quality elastic coupler to get low noise Synchronous transmissionServo-motor can be used for industrial application
SQ-135A Rotary Stage Series offers an unparalleled combination of good accuracy and high load capacity. These rotary stages utilize a precision worm gear with the worm “flexed” against the gear to ensure a proper mesh. This feature provides high repeatability with very smooth operation. Additionally, the rotary stages incorporate an oversized pre loaded cross roller bearing, offering exceptional stiffness and load capacity.
Technical Parameters
Drawing
Cross Section
2
9
10
11
13
14
15
16
17
18
19
20
12
Surface treatment
Rated Output Torque
Maximum Torque
Backlash
Permissible Thrust Load
Permissible Moment Load
Moment of Inertia
Runout of Output Table Surface
Parallelism of Output Table
Protection Class
Table Weight
Output Permisible Speed
Black coating or Painting
43 Nm
3 Times of Rated Output Torque
< 1 arc min
1450 N
30 Nm
2.918 x 10 kg.m-6 2
15 microns
25 microns
IP 65
3.83 Kg without motor
300 rpm
Stepper Motor / Servo Motor
Aluminum Casting
SQ-135A V5
Helical Gear
OD 115 mm
Bearing
18:1
360°
Transmission ratio
Max Bearing Diameter
Actuator type
Base material
Angle range
Travel guide
Model
Motor
1
2
4
5
6
7
8
3
3
Rotary Indexing ControllerRotary Indexing controller is a indexing positioner controller with PLC based control logic. In this controller HMI is provided to setup indexing angle as well as speed of rotary motion. Controller has wide array of application.
Feature
Application Photo
Equipped with Stepper Motor or Servo Motor depending upon application to achieve automatic control.Angular as well as Linear Position InputSpeed, Acceleration & Backlash SettingAuto & Manual FunctionsIngenious design to software to control backlashJogging Cycle for User Positioning.Stepper Drive or Servo Drive Included into a Single Control Panel
