2
On The Go. Make emergency repairs to plastics, glass, metal, fiberglass, and more. Can even be used to insulate low voltage wiring. At Home. Save time and money around the house or workshop. Repair glass, plastics, ceramics, jewelry, and more. Perfect for hobbies and crafts. At Work. Fills cracks and seals out moisture. Can be molded into shapes then sanded, filed, drilled, and painted. At Play. Make strong repairs on the water, in the woods, or riding the trail. Take RapidFix UV with you for endless uses and emergency repairs. RapidFix UV is an Amazing Liquid Plastic Adhesive that only sets when exposed to UV light! 6106E - RFUV-2014-12-E A Division of Boss Products USA Michigan 49441 USA 231-798-3600 • info@rapidfixusa.com Bonds and Fill Plastics, Glass and Metal File, Drill, Sand, and Paint When Cured How to use the RapidFix UV Liquid Plastic Adhesive • Area to be repaired must be clean and free of any oil, dust, dirt or loose particles. • Apply RapidFix UV to the surface where needed. Adhesive will flow and spread so apply small amounts at a time. • Build up the adhesive in layers. Each layer should be approximately 1/8” (2 mm). Harden each layer with the UV LED Flashlight. Repeat as necessary. • For optimal exposure hold the UV LED Flashlight approximately 3/4" (2 cm) above the adhesive. The adhesive will start to harden immediately. • Average cure time is 20 seconds, depending on the depth of the adhesive. Test the adhesive by lightly touching the surface. The adhesive is set when the surface is hard. MADE IN USA
