1
Installation instructions P-TRAP SUPPLY KIT Model No. 3016, 3017 Tubing Flange Waste Connector (not included) Finished wall Nut Gasket Sink drain Tailpiece (not included) Nut Trap Note: To find proper fit and alignment, check the fit between tailpiece and Waste Connection. If necessary, adjust the Sink drain Tailpiece length to align with Waste Connection height requirements. Figure 1 Figure 3 Washer (Optional to accommodate 1-1/2” connection) Tubing P-Trap Body Apply plumbers tape to threads Figure 2 Nut (Not included) (949) 417-5207 BRS-3016 Santa Ana, Ca. 92705 9/20/2011 www.brasstech.com These instructions are a guideline for a basic installation Recommended Installation by a Professional Plumbing Contractor
