Installation instructions

P-TRAP SUPPLY KIT

Model No. 3016, 3017

Tubing

Flange

Waste Connector

(not included)

Finished

wall

Nut

Gasket

Sink drain Tailpiece

(not included)

Nut

Trap

Note: To find proper fit and alignment, check the fit between tailpiece and Waste Connection. If necessary,

adjust the Sink drain Tailpiece length to align with Waste Connection height requirements.

Figure 1

Figure 3

Washer

(Optional to accommodate

1-1/2” connection)

Tubing

P-Trap Body

Apply plumbers tape

to threadsFigure 2

Nut

(Not included)

(949) 417-5207

BRS-3016 Santa Ana, Ca. 92705 9/20/2011

www.brasstech.com

These instructions are a guideline for a basic installation

Recommended Installation by a Professional Plumbing Contractor