Installation of Cisco VPN Client 5.0.04.030 YOU MUST UNINSTALL THE OLDER VERSION PRIOR TO INITIATING THIS INSTALLATION!!!! • Uninstall the old version http://ims.uthscsa.edu/communications/cisco uninstall.pdf • After removing the older VPN software, complete the following instructions: Login using your UTHSCSA login. UTHSCSA\ login and your login. Read through the Install Documentation and remember - YOU MUST UNINSTALL THE OLDER VERSION PRIOR TO INITIATING THIS INSTALLATION.
Transcript
Installation of Cisco VPN Client 5.0.04.030 YOU MUST UNINSTALL THE OLDER VERSION PRIOR TO INITIATING THIS INSTALLATION!!!!
• Uninstall the old version http://ims.uthscsa.edu/communications/cisco uninstall.pdf
• After removing the older VPN software, complete the following instructions:
Login using your UTHSCSA login. UTHSCSA\ login and your login.
Read through the Install Documentation and remember - YOU MUST UNINSTALL THE OLDER VERSION PRIOR TO INITIATING THIS INSTALLATION.
Read and Click OK if you have already removed the older version of the VPN client.
Click Next
Make sure the “I accept the license agreement” radio button is check and click Next
Click Next
Click Next
This just a screen capture of one of the windows you should see.
This just a screen capture of one of the windows you should see.
Click Finish
If you have saved all your work, please click Yes
Once the reboot has completed, go to Start->Programs->Cisco VPN Client->VPN Client
If you are on a UTHSCSA Wireless Network, such as HSCair, then you will need to click on the HSCWireless Connection Entry. If you are at a remote location, such as home, or travel, then you will click the UTHSCSA Connection Entry. To create a shortcut on your desktop for these individual entries, Right click on either entry and scroll down to Create Shortcut and left click it. Repeat for the other entry.
Once connected, you will get a UTHSCSA banner page.
Click Continue. If you notice a golden lock in the system tray in the lower right hand corner, you have connection.
