PRODUCT DESCRIPTIONA 100% solids Polyurethane coating designedas a repair material for Protec range. It givesexcellent adhesion to steel producing aseamless repair to any damaged areas. Whiteis NSF Standard 61 approved for Potablewater contact.

RECOMMENDED APPLICATIONSRepair of Protec II & Protec II PW coating.Completion of small jobs where a PWapproved coating is required but pluralequipment cannot reach the site.

FEATURES • White version is NSF• Standard 61 approved• No primer required• Meets AWWA C-222• Zero VOC

PACKAGE SIZE Volume 1 USG (3.78L)

Weight 5 lb (3.78Kg)

PRODUCT DATA

PHYSICAL PROPERTIES

COLOURResin Component is White, Blue or Grey

Hardener Component is AmberMixed product is White, Blue or Grey

MIX RATIO BY VOLUME RESIN : HARDENER 1.9 : 1

MIX RATIO BY WEIGHT RESIN : HARDENER 1.9 : 1

% SOLIDS BY VOLUME 100

POT LIFE AT 25oC (MINUTES) 25

DENSITY G/CM3 1.62

WET FILM BUILD (MM) Typically 0.50mm per coat

PERFORMANCE PROPERTIES

ELONGATION / % (ASTM D412)

TECHNICAL DATA SHEET - PROTEC II GW

PRECAUTIONS For complete safety and handling information, please refer to Material Safety Data Sheets priorto using this product.

WARRANTYITW Performance Polymers will replace any material found to be defective. Because the storage, handling and application of this material is beyond our control we can accept no liability for the results obtained.

DISCLAIMERAll information on this data sheet is based on laboratory testing and is not intended for design purposes. ITW Performance Polymers makes no representations or warranties of any kind concerning this data. For further product information or technical assistance please call +353 61 771 500.

APPLICATION INFORMATIONSURFACE PREPARATIONProper surface preparation is essential to achieve the full potential of the system.

Steel and Cast Iron should be degreased and then abrasive blasted to SA2½ using a media suitable of giving a minimum 75 micron anchor pattern to achieve optimum adhesion.

Existing Protec II coating should be abraded by flash blasting or mecha-nically abraded, feathered back to the substrate to provide a smooth transition for the repair coating. Dedust and then apply PROTEC II GW as soon as possible afterwards.

Product should only be applied in conditions where the Temperature is >7oC and is 3oC above the dew point and Relative Humidity is