http://energeticahidrogenului.blogspot.com

It works with any engine vehicles that do not have sophisticated computer systems, and are guaranteed to increase fuel savings by up to 38%**.

Our Hydrogen Converter kits Our Hydrogen Converter kits let you partially run your let you partially run your DIESEL vehicle on water! DIESEL vehicle on water!

The Hybrid offers complete The Hybrid offers complete hydrogen on demand (HOD) hydrogen on demand (HOD)

Hybrid converter kits Hybrid converter kits starting at starting at $399* that work * that work

with any enginesdfr.;/’with any enginesdfr.;/’ cx13 cx13

The Conversion Kits transform your DIESEL vehicle into a clean-burning, fuel-efficient HYBRID - INSTANTLY!

California Environmental Engineering (CEE) has tested this technology and found reduction on all exhaust emissions. They subsequently stated: “CEE feels that the result of this test verifies that this technology is a viable source for reducing emissions and fuel consumption on large diesel engines.”

The science behind Hydrogen Fuel Injection (HFI) is well documented. In 1974, Houseman and Cerini of the Jet Propulsion Laboratory (JPL), California Institute of Technology (CIT), prepared a report for the Society of Automotive Engineers (SAE) entitled “On-Board Hydrogen Generator for a Partial Hydrogen Injection Internal Combustion Engine”.

BluWave Hybrid testing has shown significant increases in fuel efficiency as well as marked reductions in hydrocarbon emissions.

Fuel savings of up to 38% have been documented and emissions reductions of upward to 70%, especially pronounced in diesel vehicles.

Converter Only BluWave Hybrid’s Converter is

precision manufactured with high quality Stainless Steel Construction, high temp and chemical resistant end caps, and has a sleek, sophisticated style. We are offering the Converter alone for those who want added Hydrogen production. Converter comes with two 360° swivel quick connect hose fittings to fit our 3/8 Super Soft Nylon Hose.

Converter comes with two 360° swivel quick connect hose fittings to fit our 3/8 Super Soft Nylon Hose.

BluWave Solution Tanks High density polyethylene

tanks have a threaded neck that fits our heavy duty automotive 2-1/4" cap. Cap is included ($6.95 value). Rugged mounting tab with slots are molded to the tank for easy installation.

All tanks have a blow molded seamless wall construction which gives the user the high quality and low maintenance necessary in fluid handling applications. Tanks are highly chemical and heat resistant up to 220°. They are opaque; you can see your fluid level in the tank.

Tanks are manufactured with three primary fitting locations, melt-weld pads located top-left and top-right of the tank neck, as well as the

http://energeticahidrogenului.blogspot.com

http://energeticahidrogenului.blogspot.comhttp://shoppinglinkmania.blogspot.com