Home > Documents > LED Lighting Fixture - Vivid Leds, Inc.vividleds.us/uploads/product/instructionspdf1.pdf · LED...

LED Lighting Fixture - Vivid Leds, Inc.vividleds.us/uploads/product/instructionspdf1.pdf · LED...

Date post: 09-Mar-2018
Category:
Author: dophuc
View: 214 times
Download: 0 times
Share this document with a friend
Embed Size (px)
of 2 /2
Keep tightly closed when in operation not exceed the rated operating temperature of the fixture. Do not install in a hazardous atmosphere, except where the ambient temperature does Make sure the supply voltage is the same as the rated voltage of the luminaire. Make sure LEDs and drivers are cool to touch when performing maintenance. Minimum size 18 AWG or 14 AWG for continuous runs. Use only UL (or other NTRL) approved wire for input/output connections. Turn off electrical power before inspection, installation or removal. in accordance with the NEC (National Electric Code) and all local codes. This product should be installed, inspected, and maintained by a qualified electrician only, Installation Guide Read and follow all safety instructions WARNING RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK Electrical Requirements Prepare Electrical Wiring Grounding Instructions SAVE THESE INSTRUCTIONS BEFORE YOU BEGIN The LED driver must be suplied with 120 or 277V, 50/60 Hz and connected to an individual, properly grounded branch circuit protected by a 20 ampere circuit breaker. Use min. 75°C supply. The grounding and bonding of the overall system shall be done in accordance with NEC Article 600 and local codes LED Lighting Fixture
Transcript
  • Keep tightly closed when in operationnot exceed the rated operating temperature of the fixture.Do not install in a hazardous atmosphere, except where the ambient temperature does Make sure the supply voltage is the same as the rated voltage of the luminaire. Make sure LEDs and drivers are cool to touch when performing maintenance.Minimum size 18 AWG or 14 AWG for continuous runs.Use only UL (or other NTRL) approved wire for input/output connections.Turn off electrical power before inspection, installation or removal.in accordance with the NEC (National Electric Code) and all local codes.This product should be installed, inspected, and maintained by a qualified electrician only,

    Installation Guide

    Read and follow all safety instructions

    WARNINGRISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK

    Electrical Requirements

    Prepare Electrical Wiring

    Grounding Instructions

    SAVE THESE INSTRUCTIONS

    BEFORE YOU BEGIN

    The LED driver must be suplied with 120 or 277V, 50/60 Hz

    and connected to an individual, properly grounded branch circuit

    protected by a 20 ampere circuit breaker. Use min. 75C supply.

    The grounding and bonding of the overall system shall be

    done in accordance with NEC Article 600 and local codes

    LED Lighting Fixture

  • Figure 2.

    Tools Required:Phillips Screw DriverSecurity Torx T-30 Bit and Driver Wire StrippersWire Cutters

    Figure 1.

    Figure 3.

    LED Lighting Fixture Installation Guide

    LED High-Bay: LED-8500

    Before starting ensure that the power is disconnected.

    Unpack fixture and ensure that there are no damaged parts.

    NOTE: This fixture is intended to be hanging using the included hook.

    Attach the hook to the top mounting plate.

    Hang the fixture on a loop and secure it by tightening the securing screw on the hook.

    Restore power at circuit break and switch on power.

    Once secured pass the cable into a junction box and connect to AC circuit branch using the supplied wire nuts.


Recommended