Date post: | 24-Dec-2015 |
Category: |
Documents |
Upload: | pauline-lloyd |
View: | 213 times |
Download: | 0 times |
MWM – Martinek Water Management GmbHMozartstraße 23A – 6845 HohenemsAustria
Tel.: +43 5576 75510Fax : +43 5576 78170E – Mail : [email protected] : www.martinek.org
Reducing water loss sustainable …Reducing water loss sustainable …Network survey and leak zone detection …Network survey and leak zone detection …
Detecting leaks immediately ...Detecting leaks immediately ...
WLM - SYSTEM
Cost effective chamber installation Cost effective chamber installation
• Installation without any interruption
• Manufactured by HAWLE Armaturen GmbH
• Easy installation and dismantling
• No chamber necessary; just a street cap
Installation of a pipe saddle Installation of a pipe saddle
•Installation like a house connection
•Use a 38mm driller
Installation of the covering pipeInstallation of the covering pipe
• This part is available in length from 1 to 2,5 m (extra sizes possible)
• Length can be cut on site adapt to the local situation
Installation of WLM-SensorInstallation of WLM-Sensor
• Cable will be put through the extension of the sensor and plugged to it. (all connections are IP68 up to 10m)
• The extension can also be cut on site to the needed length
Top of the extension Top of the extension
• Everything will be covered to avoid water entrance
• A clamp ring will be fixed on the extension for the right depth of the sensor in the pipe
Install the sensor under pressureInstall the sensor under pressure
• A special tool will be used to install the sensor under pressure
• Safety has first priority!
•Installation is finished
Only a small street capOnly a small street cap
• Only a small street cap will be on the top
• Highly vandalism protected!